VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

I would like to understand how I can implement VPNs using a cisco 1605R.That box connects the company LAN to the internet provider trough a 2M dedicated line.The company would like to establish VPNs with users using windows PCs with dial-up connectio...

We are currently troubleshooting an issue we are having with Microsoft SMS & the VPN 3000 Concentrator. Currently when we connect to the concentrator and attempt to open SMS Admin Console through the tunnel, the SMS admin connects to the SMS server,...

estjohn by Level 1
  • 1013 Views
  • 1 replies
  • 0 Helpful votes

I made a R2R vpn between two sites using C2621.I can find computerd and transfer files through IPSec, but I can't ping and vnc etc. Did I miss something or make something wrong configuration,I follow cisco example, creat access-list like "permit ip X...

nickyyi by Level 1
  • 1118 Views
  • 1 replies
  • 0 Helpful votes

I have recently purchased the required software/hardware to install the VPN capability to my 2610 router. I have looked all over your website to try to find a guide on how to install it on the router. What am I missing?

kbiv by Level 1
  • 1238 Views
  • 2 replies
  • 0 Helpful votes

Hi,I would like to connect a cisco 2610 through internet to PIX using ipsec56 and have clients from the internet connect to the PIX using vpn client software .The problem is I can configure for either one but not both.When I configure the PIX for bot...

pin by Level 1
  • 1039 Views
  • 1 replies
  • 0 Helpful votes

When I try to start the VPN dialer, the following message pops up:The necessary IPSec service could not be started. You will not be able to make a connection to the remote IPSec server.There is no indication of what causes it to fail, or what should ...

I would like to implement VPN between two sites. One site is running with Pix 520 and the second site is running with Cisco 3640 (IOS 12.0(7)).IPsec is configured on PIX with a per shared key mechanishm. What need to be done to implement site to site...

I have set up a VPN tunnel, using IPSEC, between 2 sites using the Internet as the backbone. I am using a Cisco 7200 and Cisco 3640 to form the VPN tunnel.Questions:1.Is it possible to restrict the number of users using this VPN tunnel to access the ...

dilip by Level 1
  • 1791 Views
  • 5 replies
  • 0 Helpful votes

We are currently testing IPSEC and GRE tunnels successfully. I am using CAR, for example, to give a particular tunnel a guaranteed 128K out of the serial interface into the ISP. Is it possible to use CBWFQ on traffic within a GRE tunnel? as you can...

Well I have the same task to implement a VPN, what i design was using a 3620 connected to the outside interface to PIX 515 whose inside interface is connected to the backbone switch. Now my remote clients will be runniing VPN client software. Right n...