VPN

I'm having a little bit of a problem getting a site-to-site VPN established using NAT through the tunnel, so maybe someone would be able to help me out.The internal network behind my firewall needs to be hidden since the other company is already usin...

I have a PIX 501 that I want to set up to connect to my ISP via PPPoE. This, of course, would be on the outside interface. Is it possible to enable PPPoE on the outside interface AND be able to VPN into the same interface? If so can you show me a con...

I'm having trouble getting my configuration to work properly and I've spent countless hours researching with no luck.This is a simple problem I hope. Once connected to the 2821 via the Cisco VPN Client (V5), I can access the router's LAN IP and even...

Hello,On my ASA5510 I have from link 0 to 3 (on the back of the device) these are 4 hardware ethernet ports and one MGMNT (management) port. In the ASDM I see e0/0,e0/1,e0/2 and Management0/0. I dont see e0/3. It is impossible Management0/0 to be e0/...

What is the difference between VPN client and AnyConnect Client?Thanks.Laura

I have a user that is remoting into another networks Concentrator. The user can connect to the remote network from home using his work laptop. However when he tries to connect with his laptop from our network, it fails. The VPN is IPSec over TCP wi...

We have a VPN 3005 concentrator (ver 2.5) that will drop a tunnel due to inactivity. Not unusual until you consider the tunnel can only be re-established with a ping from the remote server...but not with a ping from the concentrator. There's anothe...

Hi, I am using ISDN, on initiating the call I am getting following error, it appears like the call is initiated for a while (1 or 2 secs) and then hangs up with message "Normal call clearing".I appreciate any suggestions, as why this problem is occur...

Is there a way to customize VPN client?Thanks.

I have a client with a site-to-site VPN between a 2811 w/security software and an ASA 5505. The VPN was configured about 1 year and has been working no problem. About a week or 2 ago, the VPN will drop after 20 minutes wether traffic is on the VPN ...

hello folks,I am emulating a remote access VPN setup in my Lab setup. I get connected alright but when I am connected, the remote access client is not able to ping any of the local LAN devices and as such can not access local resource.Below is the LA...

I noticed that "enrollment url" command supports "https" and then tried to test it. I already enabled ssl support on my CA server(win2003 server). my ios configuration is:2691_5(config)#crypto pki trustpoint pcserver2691_5(ca-trustpoint)#show enrollm...

Dear Netpros,I need your help on the below deisgn to work with remote access vpn with LDAP for both auth and authrorization.The ASA 5520 is located behind the internet router. The ASA act as vpn gateway. I used the ASDM to configure the remote access...