VPN

Hi, when i create a vpn peer in my PIX or ASA, will the host gets resolved to ip address from the public DNS or it will just translates once & maintains the same ip address? bcoz my requirement will b like this, vpn.cisco.com is what i would like to...

Hi All,We have made a LAN to LAN ipsec tunnel between 2 locations over the WAN, and the details are attached.The tunnel is estalished; one sode i have a cisco VPN concentrator 3000 and the remote location i have a Linux server which is acting like a ...

Guys, I just need very simple security... I setup a router which has a 4-port switch and port 1 is VLAN 2 and port 2 is VLAN 3I Have 2 different networks running on each vlan and all works great. However, hosts on both VLANS can ping and see each oth...

Hello After connecting remotely by Cisco VPN client to VPN server I can't access domain shares .I see packet encrypting and decrypting.I am little bit confused.ping fileserver OKping 192.168.0.22 OK but net view \\fileservernetwork path not found sys...

Hi all,Were using a s2s vpn between two offices, using a 876 DSL router and an ASA firewall.The VPN drops about 15 times a day, while Internet is still going strong.We updates to IOS on the 876 to:Cisco IOS Software, C870 Software (C870-ADVSECURITYK9...

I need help!! I cannot connect to my console port via HyperTerm. I have all the settings per the doc: 8-N-1-Hardware. I've been able to connect to another 3005 with the same cable. The reason I need to connect it is to perform an Admin reset as I ...

Hello,Anyconnect it is envisaged on the VPN3000, or I replace my VPN3030 by another product?Thanks

Hi,Anyone tell me how I can get on to a 3005 concentrator when the console port isn't worling or has been disabled and no one knows the IP addresses? Is there a way or is it just impossible?RegardsAndy

Hi,I'm trying to create a site to site vpn between a pix 520 and a sonicwall tz170. The Problem is that both sides use 192.168.1.0/24 on the inside, so, i have to use NAT.they only need to reach some addresses in the 192.168.2.0/24 range so i only n...

Our customer have systems all over the world ( arround 800 locations). In these locations , there are systems that should be remotly supported. We have two kinds of systems on the remote locations1- PC's connected to analog Modems - Connection betwee...

HelloThis is my configuration:VPN tunnel between FW1 and FW2Local addresses : 10.7.1.0/24 on FW1 and 192.168.67.0/24 on FW2Behind the inside interface of FW2, there's is a remote site (network C).PC's from network 10.7.1.0 are able to reach PC's on n...

Hi,I am not able to get the connectivity for sftp server from a system which is behind the ASA firewall. For testing i applied follwing aclaccess-list acl_out permit ip source_add destination_addressI am able to reache the destinatio sftp server and ...

Hi i have 2 Cisco 877 Routersand iam strungling to set a VPN between these to devices I have tried using SDM with no joy i need nodes to access remote files and HTTP applications on both sides of the VPNregardsDean

Hi all,I've got a 1801 on which are already connected 2 site to site VPNs. They all work fine.My problem is that I want to add a 3rd one, with exactley the same configuration (same IPSEC policy) and this one can't get up!!When I paste onto this 3rd r...