VPN

Hi, I am trying to configure multiple IPSEC tunnels using a Cisco 2851 as an IPSEC gateway. The spoke sites that are connected have established ISAKMP and IPSEC SA's to the gateway, these devices are 1 x 2951, 1 x 2851 and 1 Juniper SRX. I am trying ...

Testing FlexVPN hub/spoke setup in a simple testbed, configs and diags listed below. ZBF on both routers fully opened (pass) bidirectionally between LAN/WAN/VPN zones.IOS version 15.5(3)M4a, initial config made with CCP 3.2 Problems/questions: 1. Maj...

Hi All, We are deploying AnyConnect with a profile including the connection URLs. Has anyone achieved this using GPO and if so how?  Alternatively SCCM is another method we could potentially use however that is not yet in production. Thanks

Hello Brothers. I've configured a remote access VPN on IOS but I don't got access to my servers at RDP port 3389. I'm able to ping my servers!!! Configuration from router. crypto isakmp policy 10000 encr aes authentication pre-share group 2crypt...

I need to automate an Anyconnect connection. If the user is not connecting to an office (trusted) LAN, the following is needed: 1. The device (laptop) should start an Anyconnect session 2. The user should not need to interact with this process. 3. T...

Hi all :)I have a Cisco 1941 that has a site-to-site ipsec VPN configured and working fine. The endpoint IP address is a static IP configured on the Dialer0 interface. There is also an ISP-assigned /29 network routed to us that we use for a few diffe...

Hello,in our VPN configuration (ASA5520, Anyconnect VPN Client), we have different VPN User Groups. These Group Policies are retrieved from an LDAP Server.We'd like to restrict the acess like this:A Group "Home User" might establish a VPN from anywhe...

Hi There.  I want to set up a VPN for my customer.  The customer has an ASA 5505 and it is conncted to a Windows Server 2003 network.  Now I know that Windows 2003 can be used for a VPN and it appears that the ASA can also be setup to host a VPN.  If...