Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I am installing a bridge between two 1572e AP's.  The BoM came from Cisco and they used the external antenna with three antenna connectors, instead of the more expensive 4 connection.  That is irrelevant now, so let's not bring it up My question is r...

Hello every, I am confusing regarding Flexconnect . 1. When AP disassociate to the WLC, the AP will divert to standalone mode aotomatically, right ? 2.when AP in standalone mode , the AP will authenticate the client by itself, right ? 3. In standalon...

DuJin0509 by Level 3
  • 607 Views
  • 1 replies
  • 0 Helpful votes

Hello, does anybody know how to enable wireless N speeds on this access point? It's operating in mixed mode via PoE. If I go into network interfaces -> Radio0-802.11N --> Settings, the highest data rate is only 54 mbps. Can N speeds be acheived in mi...

xpriceja1 by Community Member
  • 12856 Views
  • 12 replies
  • 0 Helpful votes

AP Model: Aironet 2702i in autonomous mode Software: C2700 Software (AP3G2-K9W7-M), Version 15.3(3)JC When I open a browser (tried IE 11, Firefox v46, and Chrome v50), I enter the APs IP address in the address bar.  I am then prompted for a username ...

Hello everyone, A customer complain WLAN network authentication fails between 1-3 mins, it is not possible to work normally , could you please give me some advise for this ? How to troubleshoot this issue ? AP is AG1130. Thank you .

DuJin0509 by Level 3
  • 3005 Views
  • 8 replies
  • 0 Helpful votes

Hi.. I have setup two autonomous access points with same SSID but on different channel(channel 6 & 11). users are complaining that they  get low signal(1 or 2 bars out of 5) though they are nearly 3-4 mtrs away from AP. I am not sure if there is any ...

Anukalp S by Level 7
  • 901 Views
  • 3 replies
  • 0 Helpful votes

Dear Team We are using 3 1532e AP’s on 3 buildings to make it a point to multipoint connection. I will be using an external directional antenna (AIR-ANT2588P3M-N=) on each 1532.My question is, will I need extra coaxial cable to connect between the an...

khan300 by Level 4
  • 3210 Views
  • 5 replies
  • 0 Helpful votes

We have a Cisco WLC 2504, we also have a spare WLC 2504. I was wondering if I can connect them in High availability mode. I have researched and am not clear whether WLC 2504 supports HA or not? Need help. If we can configure HA then can someone direc...

Top Solution Authors
Review Cisco Networking for a $25 gift card