Wireless

Hi there we just upgraded our Cisco WLC 5760 from IOS XE 03.03.03 to IOS XE 03.06.03 and every thing seems to be working fine, except that we get a lot of the following error messages:Sep 24 13:00:10: [CAPWAP] %Error: fast_ipwrite returned 2. Try ipw...

Hi, trying to get an AP to register with the controller, but it aint happening. I was reading an old post:https://supportforums.cisco.com/discussion/12503981/cisco-air-ap3702i-uxk9-flashing-redgreenoff-registered-wlcand it mentions that the AP is un-...

Need a in between solution for APs..need to find out the CISCO AP model that support standalone mode (autonomous mode) for now. AND these AP will convert to lightweight (with WLC) at later time.The current new 3700, 2700 and 1700 seems all use WLC.. ...

hello everyone, we have a problem with the ip mapping on connection of ISE and WLC. this is how is our network:vWLC: 8.1.111.0  IP:172.16.100.14          ; virtual Ise: 1.0.3.876    IP:172.16.100.17Both are on the same virtualization server.The users...

Hi! I have vWLC running on vmware.2AP 1702i joined, but ​APs is not broadcasting at all​interfaces is up, no error etc.. tested 8.0.120.0 and 8.1.121.0 release.Broadcast ssid is on, wlan is enabled and ap and wlan in correct ap group. also tested def...

Hi, When I plug in access points they will cause the port to go down on err-disable because of the BPDU Gaurd. 2602s never used to send BPDUs has this changed with the access points or something else in the system.  Is there any need for the guard wh...

Dear community,on several sites I observe same problem: clients on access point AIR-AP1242 get disconnected from time to time. One access point was converted to LAP mode, but it did not eliminate the problem.My assumption is a possible influence of o...

Hi All, I have configured DHCP scope on WLC. I am little bit confused, on interface configuration which IP should be configure for Primary/secondary DHCP server. Thank you Gaurav

Instead of me writing a whole post again I found another individual on expert's exchange who is dealing with the exact same issue as us.  We just recently purchased a couple new 3650 48PS-S switches and (3) Aironet 2702i's APs.  Signal strength in th...

We installed 10 Cisco 3600i AP's, into one of our new buildings.  The AP's are connected to a 2960S PoE switch.  The 10 ports are configured for auto power inline.  The ports show 15.4 watts.  For 8 of the AP's, Radio 0 802.11 b/g/n admin status show...

Hi all, I have come across a potential issue regarding the web auth and http server on the 5760. We are using one of these as a guest anchor controller with web auth. It initially worked fine with a small scale user count (20-30), however, on scaling...

I'm sending a GET request to retrieve RFID Tag location information - /contextaware/v1/location/tags API - and it appears as if the VendorData is limited to 128 bytes, it is also base64binary encoded. If my Tag has a vendor data payload of more than ...