Wireless

We have two 5508's in HA SSO mode connected via RP port.  When on the secondary unit, all AP's are connected without any problems.  When we force failover back to the primary, 30+ ap's randomly fail to connect.  The AP's are pingable, and on the netw...

hi all,Is it possible to monitor via SNMP the MSE (7.4 and newer)? I.e: can I configure a notification receiver which receives some traps (port 162) and is informed about the status/health of the device?I was thinking of:- hardware status- HA status ...

I need to configure Cisco wireless controller Model 5500 with WLAN for local EAP-TLS authentication without applying "user credentials" to allow all devices with matching certificates  to authenticate. Any advice how it can be done? User's devices ar...

Hello,I need to configure DHCP Server on my Cisco 1310 AP, but I don't find configuring html page about DHCP Server service.I thank you for your help.Have a nice day. Damien SIBILLEIT trainingAFPA Lorraine

Hello, as the question in subject I would like to know if it's allowed the indoor installation of the AP.Access point specifications reports outdoor use only without any mention if they can be installed internally.Thank you

Hi Cisco and Co,In our corporate environment we use Surface Pro 3 Tablets and have previously used the Microsoft Wireless Display Adapters in our TV's around the UK for our staff to project their Surface Pro screens.After a recent rollout, we now use...

HelloDoes anyone know what the rough rule of thumb would be for per user bandwidth on an AP, assuming its connected on a 1Gig port and is a 2600/2700 type API am sure I read approx 500K per user in the past ThanksMartyn

I am doing a project to migrate from WiSM's and 4400 WLC's to 5508's and was hoping to use the backed up config via TFTP to build the new configs and was expecting to paste in the config from the TFTP backup. There are a few syntax anomalies between ...

Is it possible to disable the 2.4ghz radio on the 1142 wap in controller mode through the web ui.   This is a 5508 WLC

Hello, I have got a little test network.Please, refer to the diagram.  I am wondering how would a proper QoS implementation look like. On the WLC AVC is turned on, marking protocol type X with DSCP 46 and Y with DSCP 36.Under the WLAN settings, AVC a...

Hi All, I do know that captive portal could be setup on cisco WLC 2504, such that internet users could login as follows:Username, password or  mobile number.And get the authorization code on mobile number. However I would like to know whether the abo...

have access point.works fine for a few minutes, then does not access the internet.  If i go to the wireless router for wireless connection and then revert to the access point it functions again for a few minutes, then no longer functions although it ...

Hello guys, I have two DCs, they are separate buildings, each one has its own Foreign (8510) and Anchor (5508) controllers, they have HA peering controller, but DC1 and DC2 are not in the same mobility group. Currently Anchor on DC1 connects only to ...