Wireless

Hello All I have a WLC and there were 4 APs already registered to it. Suddely they have started having problems where in it is not registering to the WLC anymore although they are getting the correct IP address and I can ping these IP addreses %Error...

Hi, Is there a way to block access to virtual IP (192.0.2.1) in the pre-auth ACL when doing external webauth?This is because I've noticed that even before the visitor/guest registers to the external portal, if they manually enter 1.1.1.1 in their web...

I have a WLC2504 with Aironet 2702i setup, is there a way to create a secondary SSID which uses 5G band exclusively ?

Hi, I apologize in advance if I'm in the wrong place, just a lonely ranger looking for answers on the grand www, will appreciate redirects, thank you.I'm a DevOps at a small cellular provider, in charge of the infrastructure of the internet service f...

I am purchasing 3 WAP 371's for a medical practice. I want the Dr's to be able to roam from exam room to exam room while remaining connected.  There are no advanced diagnostics in the practice such as X-Ray, MRI, Cat Scan, etc. It is a typical office...

Deploying some AIR-CAP3702I-A-K9. They are coming up with medium power (15.4W).  Can this be changed or should we use a PWR injector for more power? Thanks

HelloI have AIR-CAP1602I-E-K9 without WLC so i need to convert it to standalone AIR-SAP1602I-E-K9please help Thanks,Hisham 

I am able to access primary controller management with original IP address 192.168.68.200. After HA was created, from primary controller redundancy information:Redundancy Mgmt IP  192.168.68.203Peer Redundancy Mgmt IP  192.168.68.204Redundancy Port I...

HelloI recently discovered that my Prime Infrastructure 2.2.2 shows this error message for one of my controllers (the one with the most AP connected to it):STATION_BLACKLISTED moreRecentEventsQueuedAction trap/event droppedbecause multiple io request...

Hello everyone,i am facing with this issue and i have no idea what is going on.I had all my AP´s working with the WLC (X.X.100.15), the deployment and configuration of the vWLC was made and everything was fine.But suddenly some AP´s started the migra...

When I try connect the AnyConnect on my Windows 8.1, the internet disconnect. The version of the anyconnect is 5. I was look out on net to try to resolve, and all topics show me  that I have change the configuration in the VPN, but in my windows not ...

One of our 5508 controllers is showing the below in the licensing. Should the 25 license show inactive? base-ap-count  permanent  No Expiry  25  Medium Inactivebase-ap-count  permanent  No Expiry  62  Medium In Use 

Hi, We have two WLC 5580. Earlier each have 100 base Lic + 50 adder lic and total AP are 150 on each WLC. We have shifted all 300 AP lic on single controller. Now we have to configure second controller as a HA mode. Please suggest procedure.  Regards...