Wireless

 i was cleared the ap stats , how to get again ap join status in wlc 

Anybody know the equivalent command "no aaa authentication tacacs+ server" on PI 1.4. I saw this command on PI 2.2 but I can´t find something similar on 1.4. Thanks in advanced.

Good afternoon, everybody.I apologize for my English))) This is google translate)))Please help with this question. I need to set up the following scheme:WLC = 5760Lightweight AP (LAP) = 2602EAutonomus = 3501ETried to adjust instruction: http://www.ci...

Hello,I'm setting up a new 5508 WLC (the first wlc I have ever setup) and I have my WLAN setup with our existing WPA/TKIP ssid for transitioning our clients from our existing autonomous system to the wlc. I have selected PSK as the key mgmt and I can...

hi i want to use acces point air sap1602i e k9  first times i need default ip adress to setuopit is possible if not give me please solution 

Hi All, Are there any way to make AccessPoints connected to WLC 2504/5508 answer SNMP queries ?, we use it in our monitoring. Kind RegardsLars Christian Thasenhod

For the outdoor AP AIR-CAP1552E-C-K9 which controller support . 

Hi, Greetings...... Can any one please help me to understand what is next generation WIFI.  Regards,Nidhin Chandran

I read that Cisco doest support this scenario but some people say that they are doing it.Since I can't map the management interface to more than one physical port how can I register the APs to the controller?  

With Dual RLAN support enabled, does one now get support for 4 MAC's per port or just 4 shared between the two? I seem to recall getting more than 4 but after last weekend (unk reason), I can only get 3 with a 4th a set of zeros and number 5 missing ...

Hello guysI am setting up wireless network in my office using WLC 2504. I have gone through the basic setup wizard but want to use GUI instead of CLI. But don't know how to bring GUI. As on my laptop I dont have serial port so console cable is connec...

I have Cisco wireless controller on site A and connected with 1600 series access point.On my site b I have 1600 series access point no WLC .How to connect these access point over the wan. I want my authentication traffic goes to the controller.