Wireless

 Hello! I tried to download a show tech-support details, and it failed saying that the standby controller was not in HA mode. Any ideas on how to solve this issue so that I can generate and save the logs for this switch?

Hi all,I have a funny (actually not funny, more frustrating problem)I'm using Flex connect to all my remote site. l think I have 20 different locations. All works perfectly except one.VLAN 509 = GuestVLAN 510 = VLAN for production (PEAP)Vlan 511 = Na...

Windows 2003, 2008 and 2012 serversCisco 3750 switchesCisco 1252 APCisco 2106 controllersI have an issue with my MacBook pro laptops dropping the wireless signal when attempting to remote control(vnc). Anyone else had this issue? On the remote laptop...

Hi!Is it possible for all accesspoints that is configured as lightweight from a WLC to LIST all accesspoints that is not assigned to a flexconnect group? I would actually love to know if its possble both from the GUI Prime / WLC and the CLI.I've trie...

I am using a wlc2504 software version 7.4.100.0. I use MAC filtering for wireless device to connect to our wi-fi. Currently I have about 249 saved MAC address that can access the wi-fi. About once a week, the controller looses or forgets 3-5 MAC addr...

Hi.I have a customer who purchase below sku-sL-PI12-LF-100-LIC PRIME INFRASTRUCTURE 1.2 - LIFECYCLE - 100 DEVICE LIC PAK 2.00 0.00 2.00 2013-06-19 IKE HALL 100570-V07L-PILMS42-100-M Prime Infrastructure LMS 4.2 - 100 Device Upgrade License 2.00 0.00 ...

Does the Cisco Catalyst 3850 support indirectly connected access points?[WS-C3850-12S-E]---[WS-C2960X-48FPD-L]---[AIR-CAP2702I-x-K9]Would this work in any way?

HelloDo anyone know where I can get a display to Cisco Unified Wireless IP Phone 7925G ??

Hello,I have read a few article and posts about upgrading WCS 7 to CPI 1.2 via NCS. However now with Prime 2.0 I was hopping I didn't have to use NCS.I can't find any migration guides or documents about migrating to 2.0 instead of 1.x. Can anyone poi...

I am setting up a 2504. I would like to set up 1 WLAN to connect directly to an ISP switch to use as a PUBLIC network. I configured port 2 on the 2504, set up interface with an address, then created a WLAN and SSID. (Port 1 is set up as internal and ...

Hi802.11a Band status which data rates should be mandatory and which should be supported802.11b/g which data rates should be mandatory and which should be supported any advices to improve wireless performance and coverage thanksCP  

I need to see if a file is on the 5508 wlc.  What is the command to show the contents of flash? Switch = sho disk0:

Hello.I have 5 APs 3602E. They are all enabled for a/b/g/n standards. When I check client statistics I can see different clients using 2.4nGHz protocol and 5nGHz protocol. But if I take radio analyzer I dont see any 5GHz networks available((( Moreove...

If I have ssid under radio0 (2.4GHz) and the same ssid under radio1 (5GHz) and connect a dual-band laptop or smartphone to the ssid, how do I know which radio it's connected to? interface Dot11Radio0 no ip address no ip route-cache ! encryption vlan ...