Wireless

We have AIR-CT5508-K9 WLC's running with IOS Code 7.4.110.0.We are adding new authentication servers to around 550 WLC's.While adding new servers to WLAN's we disable the WLAN and enable after adding I would like know SNMP OID to check the status of ...

Hey....As the title suggests, I am having problems deleting floors and buildings from the map section of Cisco Prime. I screwed up while putting the map files in, and cannot remove them... it just times out. The only solution I have come close to fin...

hi all, When I tried to configure CMX on my MSE after adding the license  i follow these steps: Choose Mobile Concierge Service > CMX Dashboard Configuration.Choose the Location MSE that the CMX Dashboard MSE gets the maps and location data from. It ...

Hi all,In short, APs will join the controller immediately using the recovery image, but once it downloads 7.6.100 and reboots, it either cannot join the controller or will take up to 40 minutes. The AP is in local mode. The AP 1040 eventually joined ...

I know that the WLCCA tool isn't officially supported, but I for one would love to see a webinar where we are walked through some of the tricks and tips to diagnosing RF issues with this tool.  I know there are some WLCCA gurus out there, and would l...

Hey guys, what is the Cisco replacement path to WCS? We just upgraded our wireless controller and it appears WCS has some comparability issues.

 Hi Everyone, I have issue going on at our site.Users when they connect to WLC 2100  and get IP address and when they use the Remote VPN client they get connected to VPN but unable toaccess the internet sites and internal resources. Same users when t...

 Hi Everyone, On Cisco WLC 2100 when user try to auth via Radius they get errorAAA Authentication Failure for UserName:guest  User Type: WLAN USER I saw this error on WLC logs need to confirm if this error is due tosettings in WLC?settings in Radius?...

Hello All,We have set up a point to point link using two 1410 wireless bridges. The connection has been working for more than 1 year without a major issue.This morning, we have noticed  that on one of the bridge the result of the show power-injector ...

WLC 5508 is installed at our main office and we want to install LAP at our remote location.confusion is that how Remote LAP is register with main office controller?

Hello allI'm looking for stability information on 7.6.120.0.  I have recently been told by TAC that an issue I am having is resolved in 7.6.120.0 and seeing as it is the newest version of 7.6 I want to make sure that there are not connectivity issues...