Wireless

Hi,We have a couple of AP with model AIR-LAP1262N-N-K9 associated with a WLC.Whenever an AP is powered down, I can see the it get disassociated from the WLC and the Radio Oper status shows "Down". This does not distinguish if the AccessPoint is power...

Hello,My WLC5760 gets an error several times per second:*%AVL-3-TREE_FULL_ENTRY_DOES_NOT_EXIST: 1 wcm:  AVL tree 0xfba23b60 is full. Entry is not present in AVL tree.[...It occurred 33 times/sec!.]It fills the log buffer. What can it be?

I want to convert CAP-AIR 2600 access point to SAP but i can't connect to it via console ..it needs controller but i haven't.

Dear Friends,One of my client want to encrypt data over the wireless. I have cisco WLC 2504 IOS Version 7.2.0.0.Please help me on this. I think by-default data encrypt is enable. If not so how can I enable it. If I enable it is there any impact to my...

i want to ask if controller 2500 support t IPv4 & IPv6 .Shall deliver centralized security policies,wireless intrusion prevention system (IPS) capabilities,rogue access point indentification and containment,RF management,redundancy,QoS,and Layer 3 fa...

Hi,I wanted to ask if you can somehow disable / remove those clients that are in some way rejected by the wireless network, to avoid consuming system resources.for example on the wlc gui I can see many clients connected at the radio (because filtered...

Hi all,This is a lab system that I'm just building out- I try to see the obvious but it does bite me occasionally.  I have a 5508 WLC running release 7.4.1.  My AP's are all Cisco 3602E's with the AC modules.  My problem is that the Access points can...

hi, i have a WLC526-K9but it only boots the bootloader, and thats about it.i have tried the resetbutton, but i only get the secs showed that i have pressed the button, so im guessing that the software is gone from the controller, also because it 'boo...

My colleague made a change to the wireless environment and I'm trying to understand why we observed the unexpected behavior I will now describe.Prior to the change, the port configuration for all of our HQ-based WAPs was this: interface Gix/0/z  swit...

What is the maximum acceptable CPU Utilization percentage for a CISCO MWR 2941-DC router that is not prone to errors?