Wireless

Hello.I have a question about how to get Lightweigt AP from a wlc 4402-25 controller to a new viritual Controller.Becouse when I am shutting down the old controller the AP's don't connect to the new Controller.So do I have to upgrade every AP to new ...

We have CISCO 2504 controller and 1142 AP. Can we and how to setup different IP subnet for controller and wireless client ?Ex : Controller is 192.168.10.0/24   Wireless client is 192.168.20.0/24Thank you for your answer.Jason Chen

                   Hi everyone,I can connect to WLC  and i disconnect then.Wehn i am back in coverage area it automatically connects me again.Need to understand is this die to the enable session timeout settings in advanced field of SSID?IF enable ti...

Hi at all,is it possible to send the message from the NCS Server Backup via Email?Version 1.1How can I configure this ?Thanks in advance,Mario

Hello,I am trying to configure a guest tunnel between a local and an anchor WLC. I used the information posted in another discussion https://supportforums.cisco.com/message/3312270#3312270 and the config guide for version 7.2.On the local WLC I confi...

Dear Friends, I do have issue in upgrading firmware or downloading code from WLC 5508 , version 7.0. I did the same image upload with other devices through CLI from my notebook and it works fine. Everytime i try to upload/download the image, it gives...

Good morning. We want to separate the access privilege of staff and students by using the same SSID. Currently, we are using free radius linked with the Active Directory. If we want to purchase Cisco ISE, could you please tell us what kind of license...

hi,I have WLC 4400 and 50 APs attched to it.I want to take back up of both. help me on this

hiWe have offlate noticed that a few AP's keep going down at random intervals through the day.we have setup alerts in WCS throuhg which we get notification. After a restart, it seems to come back, but keeps going down again.This seems to be happening...

Hello Everyone,I am facing some problem in AIR-LAP1141N-A-K9.in this AP if 21 user connected then no one can't browse even we can't get ping from the Gateway. But if the user is below 20 then everyone can browse and we also get the reachibility to th...

I currently have a server that is operating Windows Server 2008 R2, all computers are controlled though domain from the server. The server is also sharing printer permissions to all the computers.The question that I have is when I have a guest on my ...

Hello everyone, here's full story ...I just purchased a lot of three 2nd hand AIR-CAP3502i-E-K9, that were previously set as lightweight. Since I needed autonomous APs, I loaded a 12.4 IOS first, then upgraded to 15.2(4)JA1.On first device, turning L...