Wireless

Is WCS supported if installed on Microsoft Virtual Server (Hyper V)? I have trawled through these forums and cannot find the answer, I can see some people have deployed using MS VS but cannot see anywhere that it is supported by Cisco.Thank you in ad...

Which ports must be opened? nat?AP and WLC have virtual IP adressesThanks

Hi,I have couple of users to whom , i am trying to connect to my wireless LAN set-up 1) My SSID is not broadcasted 2) WPA2 enabled SSID3) User database is integrated with AD how should i go ahead and configure iPhone as if it is part of our network a...

HelloI have a Cisco AIR-AP1030-A-K9 with me which I have been trying to configure for some time. I need to install this at our workplace which has a wired DSL connection. The problem I am facing is that I cannot view the web interface for this airone...

I dont have DHCP serverI wan to configure CAPWAP AP manually?how?

Hello,     We have LAP1242 registered to wlc. The initial config was done by someone. Now I try to access the LAP with telnet or http but failed. So is the serial port my only way to get access to it and config? However, the LAP is mounted under the ...

Hello, I don't have too much knowledge in networking, I set up the WRVS4400N, without any issues, when setting up the SR600ex to be used as a repeater I had them directly next to each other, no connection issues, I contiued to setup the unit with the...

as per reading documentation, i only see the dual-band antenna option for this device. i am planning to use this for multi-site bridging. can i substitute the dual-band antenna with a single-band high gain antenna for such deployment?

Hi allare the new generation of access points much better than the 1240 ap's on my controller?what benifits in reality do they give ?cheers

Hi,I got this AIR-LAP1142N-E-K9 bought in may 2011 which is completely dead.have tried to get in contact with the cisco tac regarding this, and they state is not under warrnanty anymore.What do cisco mean by limited lifetime warranty?

hi allwe are replacing the 1240 ag ap's with the new 3500 ones, can I use my external antenna's from my 1240 ap on my new 3500 series access points ?cheers

Hi All,i am facing the issue with controller configuration with rest of the WLC and WCS. When i do the following task manually it sync and showing ideal in report:1. Choose Configure > Controllers, and click the check box at the top of the IP Address...

HI GuysHope you well.I have 2 quesries whihc i need you advise on as folowowsThe installation of teh above card and configuration sample of this controller module on a router.\The second query which i ned you guys to confirm but from what i have seen...