Wireless

Hi.I had a discussion about this subject where I asked about ANY complications during this necessary upgrade.In the release notes NOTHING is mentioned about loosing ALL portchannel configurations for the already present WiSM cards...I asked this:----...

himy controller is a 2112 with firmware version 7.0.164I have a wcs server installed on a Windows 2003 version is 7.0.220my problemI have a configuration for the week of 5:00 p.m. to 11:00 p.m.. This configuration work- On configuration the WLAN     ...

Hello, i've got two quastions about WLC's:1)How or where i could read about access point join WLC controller in multicontroller network?2)Is it possible and if yes how i could made such scenario: I've got existing netwirk with two wlc 4402, i want to...

Hi,I am getting below error in our network which has access points 1524.AP's Interface:0(802.11b) Operation State Down: Base Radio MAC:b8:c9:c9:10:1c:40 Cause=Heartbeat Timeout Status:NA as a result , the ap disassociates from the controller , then r...

Issued the Group Policy in AD domain can be issued via a wired success，But the client side using a wireless network, Group Policy can not be issued to the client，Group Policy did not reboot the wireless clients. . . .Please help me，Think you

I am using 5 Cisco 1200 Series APs with both an A and G radio. Is there a benefit/problem to running both simultaneously? I would have one SSID and is setup for Fast Roaming as well. Thank you.

We are having an issue with some of wireless ip phones 7925g, that if not using for 2days phone becoming in a dead state and have to remove the battery and insert back to work properly. Some other similar phones in the same network are not having thi...

Tengo una red inalámbrica de aproximadamente 65 accesos point de referencia 1242 y administrado por una WLC5508, en algunos momentos en la red pasa que en un área no se llega a conectar cliente wifi y lo que observo es que los clientes empiezan asoci...

                   I am trying to setup Jabber. My problem is that the smart phones do not roam to the next access point until the rssi is so low the person can no longer hear the conversation. Is there any way to force the smart phone to roam sooner...

I am having an issue with wireless controler assigning wireless clients ip addresses that are off of the associated access point’s subnet. We have a Cisco 5500 Series wireless controller on our 192.168.0.0 LANWe have 3 subnets all of which have acces...

We have two cisco 1262 AP and a 4402 WLC, the AP cannot join the WLC.The AP gets the address from dchpI cannot ping the AP address from the WLC, but i can ping the default gateway and other VLAN addresses. I already read the info on the this link : h...

We have a site with a WLC 4400 and we would like to setup a Controller failover. The WLC 4400 is EOS/EOL and the replacement available is WLC 5508. Can someone advice me on how to configure these units in Primary /Secondary mode so that if any of the...

Hi there,we're getting the below mentioned error in our WCS console.Does anyone know what to do?Failed to retrieve metadata :[FaultEvent fault=[RPC Fault faultString="HTTP request error" faultCode="Server.Error.Request" faultDetail="Error: [IOErrorEv...