Wireless

Hi All,When I try to add new MAC entrys to the WLC I get the following message unable to add mac entry to database, reached  max sizethe problem is when I look at the stats there is only 386 MAC entry and the databse size was set to 1024 entry !!!The...

Hi, For the establishment of a WiFi Hot Spot with 5 cisco 1242AG and 5 antenna AIR-ANT1728, I want to know what the config is the most suitable. - One antenna in root mode and the other 4 in repeater mode - Or 5 antennas in root mode Between each ter...

hi i have WLC5508 and many 1142 AP . client have authenticated by ACS .but sometimes client's PC has occurred this pheonomenon.and has reconnectioned.i attached debug client fileplease check and explaine debug file.thanks

My access point 1042 series in lightweight mode reloads itselft everytime it booting, sometimes it boot succesfully, so what can be the reason guys, thank you

I've Configured AP1141N with two SSIDs but only some windows clients able to see the SSID other clients not able to see the SSIDdot11 ssid <>   vlan 10   authentication open    authentication key-management wpa version 2   mbssid guest-mode   wpa-psk...

Hi,recently we are having quite a lot of clients disconnecting from the wrieless network and the reason on the controllers is Client Association Failure: MACAddress: xxxxxxxxx Base Radio MAC:xxxxxxxx Slot: 0 User Name:unknown IP Addr: unknown Reason:...

Hello All,Doing the firmware upgrade on a 1041n AP from Autonomous to Lightweight. Downloaded from Cisco, checked MD5 and got a match so went and upgraded.  Upgrade went find etc.. and rebooted.  When I reboot I get the following error and then rubbi...

To whomever has an idea,We have recently been given this unusual task.  The setup is a series of CAP3502P access points, and a wireless controller (either 2500 Series or 5500 Series), as well as other standard network infrastructure.In this network, ...

HiI need to know the maximum number of MAC addresses that can be entered in to the MAC security filter list on the AP541N.I know it has a maximum number of 200 concurrent users, however the documentation does not specifiy whether this also applies to...

Trying to solve some issues which seems to be related to multipath issues (high CRC error counters, good coverage, hardly any co-channel interference, 5GHz) in a healthcare environment, I'm planning to lower the TX-power, but I'm also considering dec...

We have a mix of 1231 and 1242 access points in an LWAPP environment. They are connected to WiSM controllers in our 6509's and are managed by a central WLC. Everything is running version 7.0.230. My question is can I apply MAC address filtering on a ...

                   Hello,The WCS is 7.0.230.0 and the remote Spectrum Expert clients are 4.1.11 linked to remote sensors: 3502's w/7.0.116.0 and 3602's w/7.2.103.0 code.The WCS shows the various SE's as reachable and I can select which ever I wish.  ...