Wireless

My access point 1042 series in lightweight mode reloads itselft everytime it booting, sometimes it boot succesfully, so what can be the reason guys, thank you

I've Configured AP1141N with two SSIDs but only some windows clients able to see the SSID other clients not able to see the SSIDdot11 ssid <>   vlan 10   authentication open    authentication key-management wpa version 2   mbssid guest-mode   wpa-psk...

Hi,recently we are having quite a lot of clients disconnecting from the wrieless network and the reason on the controllers is Client Association Failure: MACAddress: xxxxxxxxx Base Radio MAC:xxxxxxxx Slot: 0 User Name:unknown IP Addr: unknown Reason:...

Hello All,Doing the firmware upgrade on a 1041n AP from Autonomous to Lightweight. Downloaded from Cisco, checked MD5 and got a match so went and upgraded.  Upgrade went find etc.. and rebooted.  When I reboot I get the following error and then rubbi...

To whomever has an idea,We have recently been given this unusual task.  The setup is a series of CAP3502P access points, and a wireless controller (either 2500 Series or 5500 Series), as well as other standard network infrastructure.In this network, ...

HiI need to know the maximum number of MAC addresses that can be entered in to the MAC security filter list on the AP541N.I know it has a maximum number of 200 concurrent users, however the documentation does not specifiy whether this also applies to...

Trying to solve some issues which seems to be related to multipath issues (high CRC error counters, good coverage, hardly any co-channel interference, 5GHz) in a healthcare environment, I'm planning to lower the TX-power, but I'm also considering dec...

We have a mix of 1231 and 1242 access points in an LWAPP environment. They are connected to WiSM controllers in our 6509's and are managed by a central WLC. Everything is running version 7.0.230. My question is can I apply MAC address filtering on a ...

                   Hello,The WCS is 7.0.230.0 and the remote Spectrum Expert clients are 4.1.11 linked to remote sensors: 3502's w/7.0.116.0 and 3602's w/7.2.103.0 code.The WCS shows the various SE's as reachable and I can select which ever I wish.  ...

Is it possible to use the 2 ports of MSE for link aggregation/redundancyRegardsNikhiL

We have a Cisco 4400 series WLAN controller.When I go to the clients and view who is connected; I can also filter it. However it only lets me filter by mac address, ap, wlan profile, etc.It does not have IP filtering.  Is there a way to filter using ...

Is the below Cisco Sector Antenna AIR-AP1242AG rated for outdoor installation/mounting or is it indoor mountable only?Also does anyone know if it comes with U-bolts/clamps for mounting to a mast/pole?Dimensions and Mounting SpecificationsAzimuth Plan...