Wireless

Hello,We currently have a VTC codec installed on a mobile cart that can connect via wireless or wired network.  The cart has the Linksys WET610N Dual-Band Wireless-N gaming and video adapter bridge.  If you want to go wireless you will have to unplug...

Hello,I just wanted to verify I'm actually understanding some concepts here.  A while back I posted about QoS for our Voice VLAN and it was suggested that I need to consider the Wired QoS Protocol support inside of the QoS Profile for the Platinum pr...

I see the 2500 porst are 1 Gigabit ports. Are they 10/100/1000 ports though?Have an older switch that only has 10/100 ports.Thanks

Hello Networkers!Maybe somebody know, is it possible to use this feature on WLC 2504 ? ( Passive client feature). I found just this note : " The passive client feature is supported on Cisco 5500 and Cisco 2100 Series Controllers. "Thanks!

Hi,I have some aironet 1200 AP's. I want to use this with a windows 2008 radius server. I followed the guide on http://techblog.mirabito.net.au/?p=87. Unfortunately I can not get this working. In the securtiy log of the event viewer there is always t...

Hi,I want to setup some aironet1200, using the built-in radius server of one of them.I followed the instructions from Cisco (document 67134) and configured it in enterprise mode.We don't have Cisco clients, but standard microsoft clients (XP and win7...

What are the pros and cons of 2.5 Ghz and 5Ghz spectrum My customer wants 1240AG and the antenna for those are either 2.5 GHz or 5GHZ and wants to know which spectrum is better for him to useRegardsAnuj

Hello All,I apologize if this has appeared in another thread, but it has been something I've been mulling over now for a couple weeks.  With the improvements in the 7.2.103, is there any reason to not automatically make every deployment an H-REAP (no...

I tried: disabling all firewalls, connecting directly via a cable both from a MAC and a PC,using 192.168.1.245 and the static IPs shown to be assigned to the device,rebooting it with a 10 second reset as well as a hard reboot with 20 seconds powered ...

Hi,I have two Aironets setup as below. They both have the radio configured and up. I suspect the issue is with the security. I am unfamiliar with how it works - if anyone can provide me any pointers, it would be much appreciated!thanks,Markdot11 vlan...

Hi all,we see a strange message in our WLC logs, which occurs quite often (>10 times a day):Decrypt errors occurred for client [MAC-Adress] using WPA key on 802.11b/g interface of AP [MAC-Adress]The MAC-Adresses of the affected clients are varying as...

Soon to be working on a design for a Wireless installation across one of our buildings. The wireless survery has been completed, and we'll be installing 175 APs, across the 3 floors of the building.With regards to the back-end WLC setup, I have a few...