Wireless

Hi,is anyone experiencing frequent disconnection on CleanAir APs. installed 2 cleanair aps, aironet 1550 in bridge configuration. in the vicinity there co-exist ubiquiti brand APs around 3 units. i have done frequency survey and configured channeling...

Hello,we do have a site where we need to deploy AIR-LAP1142N-E-K9 and AIR-LAP1242G-E-K9 APs. We have two AIR-CT5508-K9 controllers with SW version                  6.0.188.0.AIR-LAP1142N-E-K9s work okay, as expected, we do not have any problems with ...

Hello Guys,I got a project where I have to provide NATTED addresses to cutomers for the internal servers and I found out that the outside address range /27 already in use. We are using 5510 with ver 8.1. We cant use PAT here.Any other option to acomp...

Folks, I have a need to troubleshoot/test 802.11k, 802.11u, and 802.11r messaging. Does anyone know if AirPcap Nx + Wireshark will capture and properly decode these 802.11 amendments:802.11k802.11r802.11uI have looked in Wireshark forums and seen ref...

HelloI am getting a hard time in order to understand the real difference between the two types of context aware licenses for the MSE:1 . AIR-CAS-1KC-K9 -  Context Aware License For 1K Clients and Tags (RSSI based) 2. AIR-CAS-1KT-K9 -  Context Aware L...

I got new cisco aironet 1262n Dual band Access-point running IOS version 12.4(23c)JA .my question is does this access-point support 40 MHz channel width on the 2.4 Band on any IOS version as the command "Channel width" under interface dot11radio 0 al...

Folks,           I am new to ACS5.2, I am setting up a wirless network and want to write a policy where desktops will go in a specific vlan and laptops would go in a specific vlan. I am reading documentation on ACS 5.2 and it does talk about device t...

I have a cisco 4402 wireless lan controler, I have a campbell scientific CR3000 device with and ethernet module. When I add the device with an ethernet cable directly to the network I can see the static IP  for the device and can ping it. But when i ...

had a user who decided to install two AP's in a conference room. This per se is not a problem except the room is less than 3000 square feet. The AP's were spaced on 15 feet apart. I'm concerned that this will cause more harm than good. The reason beh...

Please keep in mind that any solution that involves a lightweight AP and controller will not work for me.  I'm aware of the limitations of wireless in an 802.11 network in that multicast traffic is treated the same as broadcast traffic and thus is no...

Hi Teami have a requirement from client and need suggestions on the design. Client has 1 main office and 5 remote branches. client requires wireless in all offices. approx 600 access points with 100 in each location client requires all wireless acces...

Have a site that has a 1522 installed. I need to add two new outdoor AP's. Would the 1550 work along with the 1522 or would I have to replace it?Sent from Cisco Technical Support iPad App

Hey everybody,It seems that a Access Point in a room where +/- 10 People with Third-Party SIP Devices are, doesn't acceppt any new Connections. If I walk in that room with a Third-Party SIP device, it doesn't connect to the Access Point in that room....