Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
When surveying with Airmagnet Survey, I've noticed my interference levels are extremely high when doing a passive survey, and very low during an active survey. I can assume this is because the card can only listen on the associated channel during an ...
When I view web page of 1410 radio is show ethernet enabled and up but radio as disabled and down. I have tried to enable but to no avail. Is this a sign my radio has gone bad?
Guys,I have a gym in a school that needs wireless coverage. I have 1242 APs and 1522 outdoor.It was suggested to use one outdoor AP inside the gym rather than using indoor one.I am not sure if there are any recommendations about putting outdoor AP's ...
Hi guys.Im looking in the behaviour and the guest user account limitations.In Europe and Nordic countries many people use special characters for thier names etc.Norway - ÆØÅ; Sweden - ÄÖÅ and so on.Since these characters are basically the same ascii ...
hi, i see there is an option to "allow password change" or "force password change" for guest roles in the NGS. But when i created a guest account using this guest role, after webauthentication , there is no prompt to change password. Is this the int...
i have a controller that has mutliple dhcp scopes and should in theory give out close to a thousand plus addresses. But i have seen wireless users not getting addresses once the controller has leased about 490 ip adds. anyone see anything like this ...
Hello world,I have the following situation:One WLC 2000 Series (software version 7.0.230.0) with multiple SSID`s, one is with 802.1x integrated with a Radius Server.Everything worked fine until fiew days ago, when users were unable to logon via they`...
Hi,I have very strange issue with my wireless Lan controller. It reboots automatically.Atleast in week, it restarts once or twice. If i want to check any historical logs , i can not check since after restarting WLC , all logs will be cleared, I get t...
Is posible stop sending of accounting-interim register in a Catalyst 6500 Series/7600 Series Wireless Services Module (WiSM) version 4.1.185.0 ??
I have an outside vendor using a Moog/Videolarm bridge device for security gate access. The moog/videolarm ap is set as a transparent bridge connecting to an ssid we have set up for them. The device connects with the correct credentials, but the blac...
Is their a comprehensive guide on the steps required to add a new, unconfigured WLC to Cisco Prime NCS? I've found bits and pieces of info on Cisco's site but I haven't been able to find that one guide that details the process from start to finish.Cu...
I am curious to know if there are any technical issues with this design. The 5500 WLC would be the primary and 2500 WLC would be the secondary. The only need for the secondary would be in the event of failure of the primary, and support needs when do...
Dear All,I'm having problem with windows sharing (file/printer sharing) from Wireless lan client which is connected to AP3500 andWLC 5508 then to Nexus 7010. It's already using ip command, for example \\192.168.84.65WLC os version 7.0.116.0 (using AP...
Ive got a couple new 5508 controllers to replace my 4404's. Im wondering though if I throw them on the network to setup, will there be any conflict witht the current access points? Will they try and join the new controllers for any reason automatic...
Hello,we have two WCS systems in our environment. One for US, one for EU. Now we try to consolidate them.I have already transfered some Controllers and APs to from the US WCS to the EU WCS.When i try to export and import a map i always get errors lik...
