Wireless

I have had our WLC4400 in place for around five years.  No configuration changes have been made to it or the 32 LWAPPs connecting to it.  We have begun to have some spotty issues with client devices.  The error message says they are unable to obtain ...

Hi,I have multiple 1230AG wireless access point in autonomous mode that I am migrating to lightweight mode so that a 4402 controller can manage them.I already migrated 4 of those APs with no problems using the Upgrade Tool version 3.4 and now I have ...

Need help to clarify this technical requirement. we are in the midst of designing a wireless Mesh AP solution for our customer.Customer Requirement:-1. Customer wants to deploy REmote MEsh APs (1500 Series) with a centralized 4404 Controller at HQ si...

HI;is there anyway to save the passwords and the usernames for web authentication ???my authentication server is ACS 5.2, WLC is 5508 7.0.116...the Clients always complaining , they dont want to reEnter the username and the passwords each time they c...

We have a problem with iTunes 10.5 and iPad 5.0 to sync using wireless.We have some LWAPP access-points and WLC 5508 running software 7.0.116. Have tried to turn on broadcast, multicast, IGMP and multicast group address 224.0.251 to support Bonjour s...

HiI have 24 other devices quite happily associated with either of the two h-reap AP's (1130) on a 2112 WLC[6.0.202.0].I cannot get a couple of Iphone 4's to connect.I have looked at the debug attached and believe the problem might be with DHCP.To get...

hi,Can any one help in configuring DHCP on access point, i have cisco 1142N access point, in my network.. working in autonomous mode, i have assigned a static ip to access point with default gateway.. from AP i'm able to reach internet and user conne...

I there.In my work place the network equipment only supurts protocols up 802.11g, and lately we´ve been experiencing problems from some users with laptops that seem to support only 802.11n, these users don´t seem to be able to acces the network.We us...

Hi all,, i have AP 1242AG , but its signal range les than 10 meters!!are there any suggestion to increase the range and the signal streangth pleaseeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee

Hello,I am using GRE keepalives to detect the tunnel down/up status.  I also use SNMP traps to send linkdown and linkup.  I noticed that even though the GRE keepalives bring the tunnel down when the network is disrupted, SNMP traps do not treat it li...

hi,i have 2 4400 WLAN Controllers in same Network , but Ascom IP Phones which is associated to theses defferent Controllers can reach via Network and can ring the phones but not able here the voice while they are associated to deffrent WLCs. There is...

HI Experts ,In my site i am running with WLC 4404 with software version  7.0.116.0 . I have configured CA spectrum monitoring tool . Frequently in my monitoring tool i am getting the below alert " Device MYSITEWLC01 of type GnSNMPDev is no longer res...

Hi guys out there,I have some confusion about the realtionship over here. For example, for a site we have 4 APs connected to one switch. The WLC is also connected to the same switch. Physically, the APs has seperate connection to each port. So , does...