Wireless

We run our ap's by 4 wism. How can Iachive that all traffic from wlan-clients is forwarded to a router and not to other wism's in the same subnet?

I'm trying to find out how to best replace two active 4404's with a WiSM while providing minimal client downtime, and would appreciate some input on my two solutions to help determine which is best.The WiSM is currently on the live network with no AP...

Hi all,did NAC guest send notification and report automatically if the guest user time is finished ,and how? i will give 5 star Regards

i have downloaded every version of drivers available from linksys and to no avail. i cannot get my PCI adapter to install with windows 7 32 bit or even on a 64 bit system. it worked fine on windows xp...and i asssume  since the drivers are old (v 4.1...

Hi,Post upgrade of our controllers to 6.0.199 two our our CiscoAP1231's didnt come back up and if we console into them it seems to be a flash error.The device will no longer allow access to flash (DIR fails) and can't get the updated image.I've tried...

Recently several of our 123AG access points have failed to rejoin the WLC after being rebooted. This only seems to happen with the 1232AG's.  When I console in to the access point I see the following error messages: *Mar  1 00:00:06.401: %LINK-3-UPD...

Hi,I have AP :OUTDOOR,AIR-LAP1524SB-N-K9 , i want to deploy this AP at difrent location , between WLC 5508( SW:6.0.196.0) and AP there are 2 nos of layer 3 Switchesconnected with OSPF.should i use DHCP option 43 to join the AP into WLC ??How it will ...

Does anyone know how to change the web settings in Call Manager Express 8.0 to change the security setting in from Read only to Read Write?Thank you!

I have a WLC 4402 that I upgraded to 6.0.199.4 from 4.2.207.0Under ports it shows that I am mirroring port 25.  Physical mode for the port is set to auto and it will not let me set it to 1000/full. Thanks

I have a WLC 2112 working fine with several WLANs and interfaces. the ap-management and management interface are in the same vlan.I found a problem, the gui admin only works if my browser is in the same vlan as the ap-management and management interf...

Hi,i have a problem on the high disponibility. In fact my LAP 1242 connect the cisco-capwap-controller.localdomain for the first time but after it don't respect my primary registred on HIGH DISPONIBILITY.Do you have an idea?Thanks.

Hi All,We have the Guest Access facility running on the CUWN and are starting to get reports of difficulties from a couple of Windows 7 users. One has an occassional problem with redirection to the web authentication page but a new one today just wil...

Just want to clarify :  when I look at the below output does it mean that "my wireless" is part of the roque SSID that the AP is seeing  or is  it part fo the configuration on the AP and is the AP's SSID ?(WiSM-slot4-1) >show rogue adhoc detailed 00:...

Has anyone deployed guest access with proxy servers? I am looking to have a guest SSID cross proxy servers so cannot deploy proxy settings with group policy and need it to be automatic.I have seen PAC, WPAD, DNS and DHCP may provide a solution but ha...

I have revised this post.The inital EAP issue was that the client was rejecting the server certificate and it turned out to be a mis-spelling in the certificate on the ACS appliance, but now that this has been resolved I am getting the error that the...