Wireless

Hi friend,I have to bridge 1400 series which  in the virtual interface has a CRC errors, i don´t the reason, maybe the link (point-point bridge) is misaligned.could someone help me.Thank,Marco.

Hi folks, First time out here on the Cisco discussion board and seeking a little help... My company currently has a WLC-4402-12-K9 in house and is up and running without issue (except that we're out of WAP licenses).With that said, I finally got mana...

Hi,Iam facing the issue with Cisco LAP getting registered with WLC 2112. Running version of WLC is 7.0.116.0. LAP is rebooting repeatedly.sh logSyslog logging: enabled (1 messages dropped, 2 messages rate-limited,                0 flushes, 0 overruns...

I there.I have a problem with an AIR-AP1242AG-EK9 access point. I start the access point and after a short while it reboots by itself, this keeps appening and the time that it takes to reboot isn´t always the same. I´ve tried different IOS versions a...

Hi,we're a small bussiness with about 20 WiFi Clients in the process of deploying WiFi VoIP on an fragmented office area of about 300m² on two levels. By doing a simple site survey of our current WiFi installation I know that we will need multiple AP...

What wireless access point should I use with my PAP2T that is being used as an ABN for NextAlarm with my home alarm system?  I have been told to stay away from the WBP54G and understand it has been discontinued, although it is still listed for sale o...

Hi All, I have cisco wireless client which is not in domain, I am trying to associate to a WLAN with 802.1x. ACS is configured for authentication and AD is used as the backend database. When I use  a local username/password the client can associate,...

I have been tasked with finding available options for integrating an SMS gateway into our UCM environment. Goggle searches find 1000s of hits without any real guidance. So I will post the question here.Are there SMS Gateway solutions that you are usi...

I have a problem where clients cannot roam between Cisco 1231g-e-k9 and recently installed \cisco 1242g-e-k9 access points..  On looking at the CDP option on the 1231 and 1242 access points they are all aware of each other.  However if I use the Netw...

Hi @ all,have anybody an funktional configuration with HP ProCurve Switches to use the LAG (LACP) mode in conjunction with the WLC 4402 or 5508 with Software version 7.0.112.0? The HP Switches in the enviroment have the last Firmware version installe...

I am trying to connect a WLC 4402 5.0.148.0 mode with an HP 2800 switch. The switch is configured thunk mode with LACP protocol. The WLC in LAG mode uses the protocol LACP? How can configure them switch HP?Thanks.Mirko Severi.

I have to propose to a client a 802.11n outdoor Acess point with external antenna, tha gain must be >8 dbi.Which cisco model should i use ?