Wireless

I have a Wireless network whit PEAP authentication, the authentication work fine, but I have this question:In the first login into the wireless the user enter the username and password created in the database local of the ACS,and the users is authent...

Silly question, but what is the default username for the SQL database that runs in the background, our WCS server crashed recently and when I try to restart the WCS server it says the database cannot authenicate. I've found the password reset command...

We have the need to add a "secondary" Management IP due to a IP rearrangement.Ist this possible?If yes, how?Thanks,Peter

Can I create WLC redundancy between 2 types of controller running the same software version ? For example WLC5508 and a WLC2106We should presume that we are running the lates Sw version 6.x.If the Primary WLC fails (the AP will have a statical config...

HiI wonder if anyone is running WCS 5.2 on Windows and has got a server backup program working with it such as Veritas. Any advice on what is compatible and what doesn't work? Is it possible to run a "ghost" snapshot type backup on the system?

Can anyone advise why I can not get config mode from the telnet console on a 521 AP? I can get enable config terminal from console.Thanks in advanceDavid

I am using about 19 pieces ofAIR-AP1242AG-E-K9       12.4(10b)JATwo of them show a frequent failure last time. The radio transceiver stops working suddenly without an obviousreason. The "WiFi inspector" shows no radio sending, but the show command sh...

Hi,I've this scenario:- two WLC 4404 located in different sites (site A and site B) with sw release 5.x- a wireless mesh area that is linked to these two sites- site A and site B are connected via L3 wired link- routers that act as a default gateway ...

Hello,Anybody can tell me if is there a tool to management and monitoring bridges?Regards,

I have recently purchased a Belkin wireless router, but am not able to get my soft phone to work properly when using this device. I am using Cisco IP Communicator over Cisco Systems VPN Client and everything works fine using my Linksys wireless route...

I'm trying to set up a web authentication disclaimer page for our guest wireless network. I have uploaded the files to both of our WLC4404 controllers with out a problem. I have tested the webpage from the controller after the down load and all the f...

I had configured Cisco  AIR-WLC2125-K9 Wireless lan controller using CLI , not configured with dhcp server only static mode.But I am unable to ping manage interface port -1. that port pingable from WLC not from outside. Where as I had already enabled...