Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi there,I am trying to use Wireless WAN as a backup alternative for my T1 connection for accessing internet when my T1 goes down. Has anyone used this technology? Any feedback on how is the speed? any idea which provider is a good option? I am in VA...
We been having issues with several laptops that appear to be losing wireless connectivity and i wanted to know if there is a debug command or commands that would allow me to see the process of the client trying to Associate/Authenticate, etc..Thank y...
Some of the 1522 AP's are not joining to the controller. I have 2 WiSM's. that means 4 controllers. i added all the four controllers in a single mobility group. all the 1522 ap's are in a single vlan, some of them are gegustered in the controller and...
Upon boot what ports and protocols are used for theLWAPP AP to find the Controller.What we are trying to do is, If we have an AP on a vendor site in which we have a Site to Site VPN connection.Can we get the AP connected and have a device on the vend...
Hi,we are about to setup a bunch of N accesspoints Cisco 1252 AP.What is the recommended image to use on the wlc to get the best stability, least bugs and highest functionality?
Hi there,I recently created a TAC request to the Cisco support regarding our WLC-2106, but they could not help me. Basically I just learned that you can create new interfaces for the wireless LAN controller and then dedicate them to a given wireless ...
Hello,Is it possible from the CLI of the Cisco 877w DSL router to see what other wireless networks are near by?This is a remote router and the only way I now is for someone to use a laptop where this router is and browse the available neworks.Thanks
Does the WCS v5x have the ability to detect Rouge APs? Also, if yes, does the WCS have the ability to generate Rogue Reports? We're looking to fully deploy WCS within our Autonomous AP fabric. However, the information we seek, will play a critical r...
I am intending to manually reset the LWAPP (1131), however, is there a way to access the LWAPP CLI? Currently, the LWAPP is stuck in a loop, thus debug message on the LAP display " No Join Response from WLC". So, because of this recurring loop, the...
WLC (4402 and 2112) running version 6.0.188 is displaying the following error in the msglog.“*Dec 11 15:13:12.185: %USMDB-3-MSGTAG030: usmdb_apf.c:262 For information regarding Emergency image Version,Please refer Controller documents”The solution to...
I am trying to set up the above hardware to take advantage of the wireless network in my warehouse. What I am looking for is Incoming PSTN calls go to the WIP310 and when I want to make a call from the WIP310, it goes to the PSTN port of the SPA3102...
Hello,can one controller 2100 be used to manage APs in the headquarter and in branches?We plan to use 6 APs-1131 in the HQ and 4 APs-1131 in the branch. Is this scenario supported by a AIR-WLC2112-K9 in the HQ?What do I have to check regarding the WA...
Hello,I have to set up a wireless network using 802.11n. I was wondering if the 4.2 version is the best one? Is there any document that tells wich version to use depending on the the configuration we need to set up, for example?jr94
Hi alli have a problem with the voice calls when roaming between aps (1130). my controllers are on version 4.2.61.0. is there something i can do on the configuration side to fix this? the phone just goes quite (silent) but the call doesnt get dropped...
HiMight be a strange one.We've got a medical deivce for Breast Care, a Solaris System, which doesn't have a wireless card,, or so the Solaris engineer says. but for some reason it trys to authenticate using CAPWAP. far as I remember CAPWAP is from t...
