Wireless

I just recived a WLC2106 and 6 ap1142. I seem to need to upgrade the ios on the wlc to 5.0, it came with 4.0.2. I cannot download the ios because I do not have a support contarct or cco. Why sell a WLC without the right IOS.Please help.

Folks, I have two wireless bridges about 200 Meters apart from each other. Everything has been working good so far. Lately I have noticed that the performance has gone done of the bridge, I am not sure where to start, any help would be highly...

I have a few 7920's purchased used. I cannot get into any configurations as it states "Not Available". I cannot use the Admin keystroke, does not work. The USB interface cannot be enabled so I cannot use the 7920 software. Any other ideas?Thanks!

We have a 44XX WLC setup for a simple wireless network. However, the Access Points do not register with the WLC. Thanks

I have a few APs that will not complete the code upgrade process after the controller was taken to 5.2.193.0 When watching the debugs, the AP starts the image data process, reaches the data transfer done point and then the AP heartbeat expires. The ...

What is the maximum number of users that one Aironet would allow without the disruption of service?

We have lots of workstation on wheels. We use EAP-Fast with Cisco ACS for authentication. When a user isn't in front of the WOW and the PAC pop-up times out, it disables the WOW and causes problems.Has anyone used some form of auto-accept method wi...

Does anyone know the differences between the releases? And why is there a NOTE in the release notes for 6.0.132 that states: "Note - Any release posted after 5.2.130.0 will not be eligible for upgrade to release 6.0.132.0."

HiI have wireless LAN Controller. I have enabled WPA. I have AAA (CISCO ACS) Server for authentication.I have individual username passwords for wireless clients. But the same username password is been used simultaneously by two different users. I wan...

Hi Netpro,Anyone know how to check the IP Address, Mask and Default Gateway in GUI ? because, my Appliance console mode is not working, so i would like to know the alternative way checking the default gateway in GUI base. possible ?your reply will be...

Hi Netpro,Anyone know how to check the IP Address, Mask and Default Gateway in GUI ? because, my Appliance console mode is not working, so i would like to know the alternative way checking the default gateway in GUI base. possible ? your reply will b...

hello i have a problem i can't reach any website when i connected with cisco vpn clienti m using vista business n service pack 1 and cisco vpn client 5.0.03.0530i have to use vpn client for check my e-mail but at this time i can't visit another websi...

Folks, I have a 4404 controller and a couple of 1240 access points. I want them to register with the controller, can anyone tell me what option 43 would be if I setup DHCP scope on the router. Also, Do i need to specify option 60?Ip address of c...