Wireless

I have a 4402 and need my guest users to be able to do vpn (ipsec or pptp) back to their companies. Can I do this?

Hello,I have a :01 WCS ( Version 4.2.62.11Host: wcs-sittType: Base + LocationLicensed APs: 500)06 WLC( version 4.2.99.0 )and 01 LOC ( version 4.0.32.0 ) deployedAt document "Location Appliance guide Configuration Release 4.0" has that version 4.2 ...

Hi allWe are using ACS4.1 AAA server and authenticatoin is working very well.The issue is that not showing log as passed authentication and RADIUS accoungting a few days ago but auth is ok.What's cause this problem?

Hi, I am setting up a new wireless network using WLC 4402 running in Layer 3 mode, LAP 1242AG and a NAC Appliance running In-band/real ip gateway. My problem is that I cannot get the NAC Appliance to assign a DHCP address to the Wireless clients. I ...

Hi Guys,In the event of a WLAN controller, can the APs assosiate to a controller a thousand miles away? The backup controller would be located in the DC where 100% of traffic is destined anyway so bandwidth is not of major concern.Thanks

Hi, everyoneI have some question about LAP's depoly and configuration.1). How are LAP connected to switch? On switch port, according to CCO, it can be configurated with static vlan port or trunk port, but trunk must be with an untagged native vlan. ...

I am in the process of designing a Wireless solution to connect 2 separate buildings that are hard to wire. In the design, I have a central building that will home all of the networking devices including, wireless bridge, and the gateway. This is the...

Hi, I just migrated our WLAN to LWAPP. Now it seems out Cisco IP Communicator won't work on the new WLAN and it gets stuck at the registering phase. It works on the LAN, VPN, but just not on the new LWAPP WLAN now. Anyone encounter this issue?

Hi,We've got WCS v4.2.62.11 and Location Appliance v4.0.32 running fine apart from enabling History Stats.When I go into the "History Parameters" menu and tick enable button for Client Station history I get an error message from WCS:-"Unable to save ...

Hello,I am running two 4404 WLC's in a warehouse environment for about 20 ap's. We use [WPA + WPA2][Auth(802.1X + CCKM)], is there anyway to monitor if a certain client is actually using cckm, I do not see any information in client details. We are ...

Hi All,I have Catalys 3560 switch, I am planning to add WLC 4402 on the network, will it work with this series switches.Regards,Abdul...

Is there any way to use Cisco 1010 Light Weigh Access Point as a stand alone Cisco Aironet device, without having a WLC. We have few 1010 LWAP, but no WLC. These AP's are based on Power over Ethernet feature. We connect these AP's to a POE based swit...

Hello,I am setting up a Wireless LAN. The encryption mode ciphers command reads that for example you can combine aes-ccm and tkip which allows for aes encryption for unicast cipher and tkip for the group cipher. What does this mean exactly? I do n...

I have cisco lwapp setup with wlc and acs server. In the ACS i have two user groups provisioned. At the WLC, I have 1 SSID each for these two groups.The target is to get each users in the pecified group eg group 1, to get into vlan 1. And the same go...

Hi,I have installed 3 1240Ag Access points in a warehouse but I have issues when connecting to any - they keep dropping connection- I have left them set to default except changing ips, adding SSIDs, no security settings.Any help would be appreciatedQ...