Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi,In our customer's Wireless LAN. There 40 x 1130AG LWAPP AP's and 4404 WLC with ACS 4.1 for the Authentication of the Wireless Clients who is trying to access the LAN. Customer is not having Cisco Wireless Clients. They are willing to use 802.1x au...

keshavahp by • Level 2
  • 497 Views
  • 0 replies
  • 0 Helpful votes

Yesterday we installed the new WCS version wih a customer, and they are now running into problems when applying a template.When they change something in the AP configuration and try to save or apply, they get an error message telling them the they ar...

koksm by • Level 3
  • 3082 Views
  • 8 replies
  • 0 Helpful votes

Hi,I have to migrate 44 IOS AP configured with static IP address. Current customer AP network is 10.10.3.0/24 for 43 devices and 10.10.4.0/24 for 1 AP device. Customer now doesn't have ,unfortunatly, a dedicated mgmt network and they don't want to cr...

dconia by • Community Member
  • 702 Views
  • 1 replies
  • 0 Helpful votes

Hi GuysI am having an issue with a WiSm module running 4.1.185, where connectivity to the blade is very intermitent, it connects for about 10 minutes and then dies, the only way we get it back is by cold starting the module by pulling it out of the c...

Hello everyone. We have recently migrated from Autonomous AP's and WLSE to LWAPP and Wcs/Wisms. I have been looking at the alerts with Rogues and have a question - im sure its been answered before but I didnt find what I was looking for so far - What...

Hi all I have install the AP 1131AG and set security WPA-PSK, I found problem that some notebook connect to AP for 3-4 minutes,and then disconnect,reconnect,disconnect.Please recommend me.Thank you.

apirachat by • Community Member
  • 1697 Views
  • 8 replies
  • 0 Helpful votes

Do you have to put both the 2.4GHz and 5GHz antenna's on a 1250 series Access Points to get maximum efficiency??, especially since it is a dual radio device.

jennyjohn by • Level 5
  • 641 Views
  • 1 replies
  • 0 Helpful votes

Hi,first one, i'm sorry for my english.I have a very big problem with the bridge. I can't configure the nonRoot bridge. It's not possible for me to turn on the radio. The software and hardware are always disable... The SSID management is configured w...

g.vincent02 by • Community Member
  • 2719 Views
  • 7 replies
  • 0 Helpful votes

I would like to Backup the configuration of my WLC`s with the WCS but the task ends with a failure message like this "Failed for some devices" and only 3 of my WLC`s are backuped.Is anybody know haow can i troubleshoot that ? Why is the backup stoppi...

gariusmar by • Level 2
  • 619 Views
  • 1 replies
  • 0 Helpful votes

I have WCS v.5.0.56.2 running on a converted WLSE. My alarms and events are showing the wrong time, they are 5 hours off. I went into the console of the WCS and verified that the hwclock and date are set right within it and they show the correct time...

bayj by • Frequent Visitor
  • 1005 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card