Wireless

Hi All,As I type the WCS Home page is reporting that I have a total of 59 rogue APs in the 'Rogue Detail Summary" table. However, when I click on the red underlined '59' WCS takes me to the rogue AP page and, guess what, the page is blank! Up until a...

Hi,I was just wondering if anyone has found a neat way of securing the Ap1010 access points?Does anyone sell kensington lock systems short enough to use on these?thanks,Matt

Hi,Could you please tell me how many channels are supported on one Cisco Aironet 1130AG...I means the numbers of users that could be supported by one Cisco Aironet 1130AG.Thanks in advanceBest RegardsMohamed

Do you know how many client can connect on a 1242 ap? I an deployment for conference room for 300 clients.

HiI have 2 WLAN Controllers in different cities. When I authenticate via the 1 to a local ACS server it works but from the other one I get "EAP Type not Configured" on the ACS logs. Both on the same OS, same ACS server and identical configuration. On...

HiI have tried to get video streaming working over wireless. I am having problems getting it to work on a Cisco 877w. It works on a Speedtouch wireless router.Setup:PC running Tversity media server located on 192.168.1.10 - LANXBOX 360 receiving the ...

I am just wanting to check and see if I have good signal strength, hard to find documentation.I am using 802.11a with the 1400 outdoor bridges. Signal strength is -35. I am used to 802.11g where it is usually -45 to -65 that is considered good, what ...

We are using Live Communictions Server (LCS) 2005 and Office Communicator (MOC) 2005. We would like to protect this traffic. I am wondering how would you do it? I thought about using nbar rtp video, but was curious, does the MOC client use a specific...

Dear experts:I have a Cisco Access Point, connected to a Windows Server 2003 network with DHCP enabled.The wireless card on my new Latitude D530 is not getting de IP address, instead it gets an odd 169.x.x.x number. (Windows XP Pro)If I manually set ...

After an upgrade of both controllers on a WiSM module from 4.1.171.0 to 5.0.148.0 the first stays in"Operational Status of the Controller : Started KeepAlive"Even after setting to factory defaults or repowering the module.Any idea what's problem

I'm running 12.2(18)SXF11 on a cat6509 with two WiSM module; one module is fine (after many reloads...) but the 4 Gib-ports of the 2nd controller are not assigned to the auto created Portchannel (Po290)Any manual intervention is denied.What to do her...

Hi All,In the WLC deployment guidehttp://www.cisco.com/en/US/docs/wireless/technology/controller/deployment/guide/dep.htmlIt has a very nice and easy way to understand how traffic is passed from the wifi device to the LAN device as listed below.Now, ...

What, if any would be the best solution to deal with users connecting to a wired infrastructure but also connected to another organization wireless? We want to only permit wired when connected. The end users are not domain controlled but 802.1x authe...