Wireless

Hello All, Looking for information related to "Restoration of configuration on cisco 9800 controllers where controller fails and you will need to restore its old configuration"I have cisco 9800-L-F-K9 in HA and failed, i have got the RMA but i don't ...

Hello Team,I have two 9800 wlc running in HA-sso.in the current set up around 800 access points are registered with the wlc.Is there a way to update the High availability in all the access points at a single time.because configuring individual access...

We are wanting to add 2 more links (one to the active controller and one to the standby controller) from our L3 wireless core to our WLCs that are in a HA pair. What is the best way for us to turn on that interface on the standby controller? Is there...

Hello,I work help desk for a small health organization. We had a user place a ticket that whenever she is in her office/hallway her "internet is dropping" on her laptop and on the iPads in the same hallway that we use for translation with some of our...

Hello, I'm looking at enabling secureweb for webauth guest access on the 5508 (v8.2). The controllers are currently set up as a SSO pair. I did read that someone (below) mentioned they were able to install a certificate ok to the active, but installi...

Hi,I need an overview from all the access points and the assigned PoE (Power Status).Due to sometimes bad cabling an AP is running on Medium PoE, but there is no warning (except flashing color leds).I have tried it with: show ap config general | incl...

Is there a way to push or install a third party certificate chain in LAP (C915AXI-E) from WLC (C9800-L) without using the LSC enrolment procedure ?

want to check for the end of life for Cisco Access Point - AIR AP3802I-H-K9 

Hi, On Prime I am getting this message: Controller '10.0.0.148' detected duplicate Ip address '10.2.48.8' being used by machine with mac address 'cc:46:d6:59:7b:53'. 10.0.0.148 is the Management IP Address 10.2.48.8 is an interface configured on the ...

We have a few pairs of 9800-80 and approx 13k APs. We would like to start using the AAA local Device Authentication for AP join, but since we use redundancy between the HA pairs we need to identify the capacity and the load that this new service woul...

I'm curious whether it is possible to configure virtual IP to be able to monitor active WLC from HA pair via SNMP. So let's assume I have HA configured for 2 WLCs: WLC1 and WLC2. I want to configure virtual IP to monitor always active WLC from this p...

Hello Team, This is my first engagement in Outdoor Wireless Design / Troubleshooting. We have a Client who is having issues in Outdoor Wireless . They are located near the Airport / Establishments so they are getting continuous radar hits on their ou...

Hello ,I'm trying to send a test BTM request to client using test wireless 11v command. But it doesnt add/delete any neighbor as per  command.cisco 9800 + 9120 AXEtest wireless dot11v btmreq prepare 18f9.3565.4980 1 9test wireless dot11v btmreq candi...