Wireless

Hi,After reading a little on possibilities for implementing a multi-site Guest Wireless Access solution, it seems to involve alot of expensive gear.Is it possible to implement same on multiple 877W's, for example, using the Consent Feature, available...

Have to setup a wireless WAN in VERY remote area for Video Surveillance in outdoor Park back to security center. I have access to current or will use Solar. 9 key Points (so far )to connect in large valley. Want suggestions on using CISCO 1400 Bridge...

Good Day!I am aware of the controller command "config ap username 'user' password 'pass' all/cisco ap"However I am wondering if it is possible to actually get a login prompt from the lwap console. Entering the command specifies a username, however yo...

How many devices can an AP350 handle at the same time before loosing ThruPut? Are all of the following: Ethernet Clients, Repeaters, APs, WGBs, DS Nodes defined as devices?Thanks in advance.

Is anyone having issues with Symbol handheld units just losing connection. I see no errors on the ACS server and cannot see that signal strength is an issue.

Hi, I have a CISCO Aironet 1130AG and I want to secure it with a WPA key without Radius serverHow can I acheive that ?ThanksFrederic

I am very new to configuring Cisco WLAN's and I am aware that this is most likely a very basic question. I would like to use (2) Cisco 1131's in the same office to obtain total WLAN coverage of the office. What is the best way to accomplish this?

I look site manager (location manager) this morning and 20 buildings lost all aps, and there are no one in Unspecified location windows. WLSE is 2.15.1.I have use a backup copy, but the error dont resolved. And all aps are in device center.All lost a...

Hi all,I need to config wireless mesh system.I have Wireless Control System, Wireless Lan Controller 2100, and access point 1310Any one can tell me step to config this sys tem.Thanks all, vote 5* for your help.

hallo,in a Basic Service Set the mobile Stations must exchange data throughout the AP.Before transmitting a Station must sense the medium by radio and NAV.Suppose we have 2 stations, sta1 and sta2 NON hidden each other.Suppose sta1 transmit a frame t...

Hi to all,I've a little problem with three Cisco 1130 AP. Anticipately i tell you that i'm not a guru of cisco wireless, but my implementation is very simple. I need a roaming for the 3 AP. I only have Ap, so i configure one as Master Ap and the othe...

Installed new 1240 to replace a bad one that got zapped by lightning. Tried to use the IPSUtility to get it's IP, but it only pukes "Device does not answer" at me. I have checked to make sure that no L3 devices are between me and the AP, to no avail....

Was working fine yesterday. Today when my phone boots up and connects to the network. IT seems to go through the AP fine. Then connects and authenticates and starts downloading config file. It drops after that and I lose access to all AP and I have n...

I have an existing Cisco 1811W router, running just fine, but now I need to turn on wireless. All of the web docs that I see seem to involve turning on bridging? shouldn't it be sufficient just to put the Dot11Radio0 and Dot11Radio1 interfaces into t...

Hi all,I am trying to import a DWG CAD file to my WCS 4.2.62.0 for a floor area. Everything I read says I can import DWG CAD files (as well as gif, jpeg, and png) for Floor Areas but I am unable to do so. I get the following error message:The image f...