Wireless

I just installed WCS 4.1 and have a test rouge AP. I've been doing some testing with containment, but somehow deleted the rouge AP alert in WCS. I see the rouge AP in WLC, but it's not showing up in WCS. How do I get the rouge AP to reappear in WCS?

cisco 1100 software was be disabled,and hardware down. But i can telnet 10.0.0.1, How to sovle it? To enable the dot11radio.

All, I'm in Iraq and I was using the "B" side on at 3 miles away with a solid dish "AIR-ANT3338" and was getting 2meg down on by bandwidth and now I'm lucky to get 400K. I have one root hub and 4 non root hubs linking to it with no more than 6 users ...

hallo i have version 3.2.78 on my wlc 4402 and i want to configure it for EAP-TLS. it should be secured by 802.1x and wpa2 but i dont know how to do it properly over the webinterface. every suggestion is appreciated.

Hello,recently I've installed a Cisco WCS server.In the MAPS section I have added a map (outdoor area) and I have dragged the two access point in the map(1 RAP and one MAP) to see the heat map of the signal.The problem is that for the first 2 days it...

All,I have WiSM rev 4.1.185.0. I try to make some WGBs using LEAP and TKIP together with a client username and password. However, no matter what I do the WGB cannot associate.The documentation I found on this only goes as far as wep, no TKIP/AES and ...

We have an issue with a Fujitsu Siemens Amilo Laptop. It uses 802.1x with dynamic WEP and PEAP-MSCHAP (MS-IAS), Verisign Imported Certificate. It works fine in a Autonomous environment but fails in Unified environment. Other laptops work fine in both...

Hi, I am implementing dot1x with PEAP for wire and wireless access, before I get CA running, I am using ACS server self-signed certificate. However, XP client won't be able to authenticate if I have the "validate server certificate" box checked. I di...

Hi, are these AP ready for sale now, cause I do not find them in the ordering tool?For them to work with 802.11g standard, should I configure the same antenna types used for 1200 series, and is it necessary to place the 6 antennas?

Recently added WPA2 and wlans in our test lab to 350's and now rf units are having issues staying connected and timing out. Logging history reports following message constantly: Interface Dot11Radio0, Deauthenticating Station Reason: Disassociated be...

What do guys thinks between the following product for a site survey:OmnipeekCognioair magnet

I was wondering if anyone has worked with Innerwireless with Cisco LWAPP solution. I want to know if there are any drawback to using innerwireless instead of the normal AP design. Critical applications will be used on this wireless system which will ...