Wireless

hii have a Lightweight Access point that connected to a non POE switch.and its tacking the power from the power injector.Is there any problem will appear when I change the configuration at the controller (( it will ask to reboot the access point)) bu...

We have just received a demo 7921g phone and I want to add it into call manager, however my current version does not have 7921 telephones ad an available phone type. Does anyone know what the procedure would be to add 7921g phones in my version? Is i...

I have been attempting to setup a HWIC-AP-AG using the Wireless Application via SDM. Whenever I try to submit a change over ANY of the configuration forms, I get a 400 error. I've formated the flash, deleted the startup-config, reflashed the IOS, and...

We currently have 3 Linksys WAP54g access points using WPA-PSK.We would like to be able to authenticate users instead of having one pre shared key for everyone. It would be great if we could authenticate against our Windows 2003 active directory. One...

1100 running IOS 12.3(8)JA2. Upgraded the radio from b to g with AIR-P121AG-A-K9. When the AP powers up with the G radio it gives the following error message when loading 5101.img from flash tar file- Interface Dot11Radio0, failed - Radio configurati...

We only allow guests to access internet through wireless. How do you determine how many guests or computers can an Access Point handle at the same time?Thanks.Diane

Hi, I have been searching high and low but have been unable to find information about these commands. If anyone could point me in the right direction it would be much appreciated. Thank you. bridge-group 1 block-unknown-source bridge-group 1 source-l...

We have a large deployment of the 1242 AP's and I was wondering if there's a way of determining the exact number, short of counting them off of the controllers on the WCS?thanks.

The instant I enable web auth on my 4402 the web management interface becomes unresponsive. The only way to regain the use of the web management, is by connecting to the CLI and issue:config wlan disable <WLANID>config wlan security web-auth disable ...

We are having a problem with our Aironet 1200 APs. Currently, when someone disconnects from from wireless, they have to reinput the encryption key in order to reconnect. They cannot input the encryption key via the 'View Available Wireless Networks' ...

Dear All, I have to set up a VLAN with one AP (1242AG) as local authenticator and about another 7 APs for coverage. Does it make sense to make the local authenticator AP (which also provides radio coverage for clients) the WDS master ?

Hello everyone..I am seeing an issue with clients being disconnected from an AP after periods of inactivity.Is there a "idle timeout" that is configured to disconnect clients after a certin time?Thanks in advance!

I have about 20 IPAQ devices running an application called "Bed Tracker" in a hospital environment. These devices update real time to allow nurses to know when a room is free and can be re-populated.My issue is this... I have 8 SSID's and only one of...

Hi....I have a LAP 1131, this access point is succesfull registered in the wireless lan controllers, I connect the access point without power injector and their radios are up (LED status Green), but when I connect the AP with power injector the radiu...