Wireless

hi, please can i use an anntenna of Bridge AIR-ANT2506 for wireless access with access point 1300, the problem is if i have to use an access point annetana or can i use this bridge antenna for wireless access (for users), because it gives good signal...

Hi All,What is the greatest distance supported using 5GHz backhaul bridging for the Cisco 1510 MESH AP's? What the max data rate with 2 hops over a 7 mile link?

We have a WISM blade with two controllers enabled. Single mobility group and no AP groups. We keep having random disconects when our users are in Citrix. Some sugestions I read say that I should enable CCKM. We turned on 802.1x+CCKM on one controller...

Hi do i enable spanning tree portfast on a switch connting to a ap1200 my current configuration is:interface FastEthernet0/20 description Wireless_2_W_1 switchport trunk encapsulation dot1q switchport mode trunki am getting a lot of flapping and was ...

We use WiSM 4.0.217.0 and SUP720 12.2(18) SXF5. We experience bad performance with wireless client download, for only about 70kbps. I tried with a WLC2006 connected to the same SUP720 with similar configurations with WiSM and I got 2Mbps download spe...

I would like to configure APs such a way that administrators should access the APs using web interface. I have AAA authentication set for users pointing to RSA secure ID server. What should I configure on the AP or on RSA secure ID server so that adm...

Hi.Im running a 4404 (4.1.171.0) and WCS. I imported all the maps, placed the AP's etc.Looks great! I can find rogue AP's no problem and place them on the map with the skull and crossbones.However I cant figure out how to do rogue CLIENT mapping. Im ...

All, Im having an issue trying to get my second SSID to work. I can pass traffic just fine with my SSID#1 (get to servers, internet, etc), but I cant do anything with the second SSID#2 I setup. Can you guys see anything I have done wrong? Id apprecia...

Hi all,I implemented "guest" wlan with web authentication (login+password with expiration). How can I protect these guests from being sniffed on the air. I speek about preventing "arp spoofing" and "man-in-the-midle". Shortly I want cause guests don'...

Dear We have placed 4404 controller along with 50 light weight access point to provide the wireless service across the floors. Currently the wireless segment are divided into 3 segments1. Guest 2. Voice wireless 3. Secure Data wirelessThe requirement...

Hi all,is there any issue configuring the management interface as the interface for a wlan in a wlc environment?I ask that because I need to map a wlan directly to the production lan, where the management console and the various services (dhcp, dns, ...

I'm stuck...I have several older P3 and K6 systems that won't even POST when I have a PI21AG card inserted. I have looked everywhere I can think of with no success.TIA, Kirby

I've got over 90 APs installed and displayed on WCS but with one particular building, neither of the two floors will display heatmaps. Instead there is an error message that says "Error(s): You must correct the following error(s) before proceeding: E...

I have enabled redundancy between two WLSE Express 1030 version 2.13.1, but it fails to copy the database and the config files. I have the errors:- Failed to backup database- Failed to backup config filesConnectivity between them seem to be ok, becau...

Hi, In MESH technolgy, how many MESH AP's can be supported by a MESH ROOT AP.