Wireless

Hi,I've a trouble with config group in WCS 4.0.97 with the following step:- set-up 2 templates ( server authentication )- selected 3 controllers in the same mobility group- applied these 2 templates to the controlles ( all worked fine )- checked with...

Hi all,Can somebody ,please, clarify for me what the command "show dot11 statistics client-traffic" shows to me? The output usually looks like:xxxx.xxxx.xxx pak in 24289 bytes in 5050182 pak out 32230 bytes out 35936358dup 47 decrpyt err 0 mic mismat...

We had a strange problem after installing a 4402 controller and several new 1131 LWAPP ap's.Many of ours clients did not receive ip when trying to connect to the network. Then we discovered an older ios ap powered on. When we powerd this ap off, the ...

Hi Sir,I found the following from Mesh 1500 datasheet for its power requirement, 95?260 VAC, 47?63 HzPower over Ethernet: 48 VDC, +/?10 percentHowever, my contractor requested me to give him in Watt as UPS is provided to it. Can anyone show me the fo...

Can I know the tool by which I can measure the signal strength and the S/N ration and the IP address and the rest of the detail?can anyone help me on these.

Hi,I'm in the pre-sales stage of a new WLAN for a large(ish) hotel (32 AP's). We are proposing a 4402 WLC and AP1010's.It turns out that the customer does not want the added effort of generating one time user credentials for the guests. Is there a wa...

I have an AP that has been upgraded by someone else. The 802.11g interface does not come up, and an error message "*Mar 1 00:03:15.367: %DOT11-2-NO_FIRMWARE: Interface Dot11Radio0, no radio firmware file (flash:/c1200-k9w7-mx.123-8.JEA/5501.img) was ...

Does anyone know? I'm mounting patch antennas on an outside wall, drilling a small hole in wall, and connecting the antennas to a 1200AP on the inside wall. I plan on setuping up a fiber segment on the cable run to the switch. My questions, 1) Should...

Hello to all. I have configured migration mode in the network wireless for LEAP and WPA, I have problems with a card linksys WMP54G, if I disable the migration modefunctions well, some aid.Thanks

I need to install patch antenna, Model: AIR-ANT2485p-r, on the outside of a temporary office trailer. Is it good practice to mount the antenna flat, directly to the metal outside wall or do I need to get somekind of mounting kit and mount the antenna...

I can to have two SSIDs for all branch of my country, but each ones in a differents subnets,for example:Area 1SSID 1 : guest -> 192.168.1.1SSID 2 : office -> 192.168.2.1Area 2SSID 1 : guest -> 192.168.3.1SSID 2 : office -> 192.168.4.1Area 3SSID 1 : g...

I just received the 871 and attempted to set it up; it replaces a Nexland Pro400 router. I've got Cox internet, they've told me that I don't need a username or password to get an ip addr from their server. On interface Fa4, I specified 'ip addr dhcp ...