Wireless

I have a Cisco AP that Cisco Aironet adapter is no longer picking up with Scan. My internal Intel wireless card can pick up the AP, others using their Cisco cards can, and my Cisco card in another laptop can pick up the AP. I've uninstalled and reins...

Hi Team, i had a problem with the active (associated) survey in a WLC Deployment. The Airmagnet did not Roam from one AP to another. Has anybody seen this Problem and possibly an Solution? Regards, Michael

HelloI would like some opinions on how to perform a site survey when surveying for both 2.4 and 5GHz. Assume that the installation want good coverage on both 2.4 and 5GHz and that they use dual radio ap. Should I map one radio cell using 5GHz and the...

I have a real simple question. In my Cisco 1200 access point configuration file the WEP key line looks something like this...encryption key 1 size 128bit 7 BA41D6B702925C981BA4142B70C9 transmit-keyMy question is, is that the actual WEP key or is it a...

Does anyone know what the default power level is for 1240AG's in U.S.?I've looked for it in documents I found on cisco.com but they only tell you what the max power is and how to configure them.Also, how do you see what the current power level is in ...

Dear all,Is there any limitation on the # of user connect to one AP 1240?Besides, can I use the cisco aironet site survey utility without the cisco adaptor card?Thanks.C.K.

Anyone tried Cisco CB21AG Card with WZC WPA configuration? I can configure and use WPA with ADU no problem. But when tried with WZC, no WPA option available. The computer is XP SP2 and the card is with latest driver 3.0.Thanks!

My APs disassociate from WLC every hour, so I completly lose the connection.0 Fri Sep 8 17:29:09 2006 AP Disassociated. Base Radio MAC:00:17:0f:da:f2:60 1 Fri Sep 8 17:29:09 2006 AP's Interface:1(802.11a) Operation State Down: Base Radio MAC:00:17:0f...

I am trying to set an aironet 1010 for use in a site survey. In my class, the book showed a jumper under the access panels. These APs do not have the same set of jumpers. J31 has 3 sets of pins while J49 has 2. can I set this 1010 up to run independe...

HelloWe are trying to implement EAP-SIM with Radius (Lucent Navis Radius) and the Cisco AP 1200 and the "Option GlobeTrotter Fusion+" PC Data Card.In the datasheet of the AP 1100 I found the support of EAP-SIM. But I didnt in the datasheet of the 120...

I just bought a aironet 1200 and a 10 DBI YAGI antenna, problem is I cant communicate with clients connected to my aironet 1200, I can ping via the aironet command line but not with computers behind my ap.Is it most likely a config error or has someo...

HiI have 3 AccessPoints 1242AG running on the same subnet. To keep it simple I configured only one AccessPoint acting as a Radiuserver and on the other 2 AccessPoints I point to the correct AccessPoint(the one with the Radius configured). But when I ...