Wireless

I shoudl start by saying I know very little about administering wireless devices. My company had a third party install a wireless network that I am now responsible for. The problem I have is that I have a couple of devices that don't seem to be worki...

Hi Sir,I have deployed a LWAPP-based wireless LAN recently in one of my customer office. Here is a brief description of the setup.2 WLC 4404-100, one acts as a Pri Controller, the other as a backup. We have tested APs failover to the Sec WLC and vice...

I would like to know if I can make authentification first with mac-adress, and second, after with EAP-FAST on ACS server (based on user rights) ?

Hi all,Im looking for some application to manageand reasonably place our APs in our office.I want to import our building plan in toapplication. Is over there anything on thenet for free. I know that Cisco has WCS. But as I understand when I want to m...

I'm looking for documentation on how to manage wireless devices (Aironet {all models} and Wireless LAN Controllers).I'm not all that familiar with the Wireless products and I'm not interesting in using any tools or web-browsers to do the job, only ab...

hello, What kind of roaming can I expect with the following setup : - leap authentication- aes encryption- windows CE scanner and funk odyssey supplicant. ccx v3.- WLC 4402- AP1242I think that roaming is possible with tkip, but here I'm not doing tki...

According to the installation manual in a point to multi point configuration one device should be a root-bridge a the others must be non-root bridge. This is working fine. From the root bridge I can see the true CDP and ping the other devices. with o...

I've got 40 AIR-LAP 1131 APs, in our building. As I approach the 1 in the stairwell with my laptop, my signal strength drops from full bars to barely 1 bar when I get right in front of it(it's mounted on the concrete wall appx 7 feet high). Concrete ...

I can't get any of my routers, 3845, 3825, or 3745 to recognize my nm-air-wlc6 cards (i have 2 cards). I'm using an IOS at the recommed version level. Has any one else experienced this issue and how was it resolved?Thanks,Josh

I have changed our network over to WPA with PEAP. One the questions that has come up is, how can guest still have access to this wireless access point to access the internet, but not have access to our internal network. Any info would be great.

I have a need to set up a guest wireless network for some class rooms in our office. We have about 50 new users coming through every week and the administrator doesn't want to have to create 50 new guest user accounts each week. I'd still like to hav...

Hi.I have been reading the guide "Configuring ports and interfaces in 4400" and I have one dude about how can I support more than 48 AP in 4400.The guide says "The access point then joins the controller using that isolated VLAN with Layer 2 LWAPP. Al...

Ok, I have been going crazy for 3 days now trying to get 2 Aironet 1310 AP/Bridges to connect the Root Bridge and Non-Root Bridge using Microsoft CA, Microsoft RADIUS and network EAP. I don't know if I'm just not getting it or what. The Non-Root brid...

Assumed that we have a wireless network infrastructure for a building that contains 4 floors and each floor has two different VLAN with one cabinet (switch support PoE). In addition the data center was built by a different building and connected by f...

Hi,can I use 2 Antennas (2,4 GHz) on 1 Cisco 1242 Access Point, working at the same time.I know, that you can configure the AP to use "Diversity", but it seems that in this case only one antenna is used by the ap at the same time.Can I configure the ...