Wireless

Dear Pros:I am looking to give my users full access to the production network, but vendors without credentials access only to the Internet. Unfortunately, a lot of our internal web content is wide open, and management is concerned that vendors could...

I am working with an apartment complex and they want me to setup a wireless network for all there tennets. If on a map I drew a circle around the apartment complex it would be 1000ft Diamater. What prouduts should I use and any suggestions on where t...

Hi everyone. Im having a little problem with 2 of our AIR-1232AG-A-K9.The Ethernet LED is flashing amber, Status is flashing red, and the radio is flashing green. Any thoughts?Thanks,Matthew.

Hi, I am trying to get my 870 router to assign DHCP addresses to wireless clients. The wired LAN works fine. If I assign a static address to my laptop it seems to work fine. Just not DHCP.I have posted my config.....Any comments appreciated

Hello,I´ve connected several AP1200s connected to a WS-CE500 switch with Smartport Role Wireless configured on the switch.Additionally I´ve configured several VLANs on the APs and the Switch.Everything works fine except Layer2 Roaming between the APs...

hi allI've noticed the following bbsm behavors:first :if user disconnect without using disconnect pop-up bbsm will never authenticate this user for the next web connection whatever the aging time in switch config.the only way to kill this session is ...

We have enabled the Helpdesk role to view the AP location in WLSE. However, some helpdesk staff have moved our AP in the location manager to different location. We have to move the AP back to the designated location.Using WLSE 2.13, anyone has idea i...

As with most environment, we have wired and wireless access. The concern that we have is that when wired and wireless access are concurrently done, there is a security issue - the wireless side can be infected with malware and via it, it could spread...

We are looking for a good mini pci (not pcie) card that supports ccx4 (Cisco Compatible Extensions version 4 [added to improve searchability]) and has good client software. Our environment requires use of eap-tls with machine certificates, so ccx4 is...

Hello All, I need to find a solution for blocking unauthorised laptops being connected to my network. Is there a tool that I can use to find out from which jack and switch port the laptop was connected and also what method should I use to distingui...

Greeting,My AP is at ap: mode after I get the massage "The system is unable to boot automatically because thereare no bootable files to boot". I can not figure out how how to re image, please assist.

Two problems.1.) 4 workstations on the same subnet, 2 can consistently ping and reach the web interface of the WiSM. 2 workstations cannot ping the WiSM, but can reach the web interface.2.) Second WiSM configured, but cannot ping or reach the web in...

Customer has 3 access points, all 1231's running 12.3(8)JA2. One of them is located in the main building (AP1). The 2nd (AP2) and 3rd (AP3) access points are located in building 2. AP2's antenna is outside and AP3's is inside. There is a crossover...

We are using AIR-PI21AG-A-K9 cards to connect to Cisco 1100 AP's in a Win 2k domain. After the card has been installed and configured, the PC experiences extreme sluggishness when booting up, to the point it completely locks up. If the radio is dis...

I have a 4400 series controller capable of 25 access points. I currently have 11 deployed and the controller is only seeing 10. Also if I have the need to reset a switch the AP is hanging from it can take days for the AP to find itself again, if it f...