Wireless

Hi all,We connect the wireless LAN with PEAP for authentication. The back end RADIUS is using Cisco ACS with AD domain username and password. Can I use the RSA SecurID instead of the AD username and password for authentication? I configured the ACS t...

I connected my Aironet 1200 to my network using a power injector. My switch can see it and its ip address. But when I ping that IP, I get request timed out. My DHCP server doesn't see it either, even though it must have given it the address. Using th...

You may be able to help me or direct me to the right direction this is the problem. I am trying to get ready to take the exam 642-577 Wireless LAN design specialist. I could not find a single book that address the Cisco objective exams for the this t...

We switched from the 350 aps to the new WCS solution. Previously, we were able to monitor associated clients per AP and roll the data into MRTG & Cacti. Is there a way to do it with the airespace APs or controllers? The OID for the aironet was .1.3.6...

I made my wireless network public, and I would like to do first page for all users which shows that this is my network and you are not allowed to do some thing (I will thing about what to write there).So my question is: is it possible to do it on my ...

I have "special" solution.(see. attach.) please.Where is the trouble? On tower AP in LOG is in 5min interval generated mess...Dot11 radio reset, down ...than Up and so on. Communication with all clients and ROOT-BR(BR-350) is broken and all of them r...

We are running a pilot project to deploy a centralize wireless solution for our campus. The pilot consists of only about 20 Cisco1200 access points. We are in need of Network Management solution to manage these access points. The NMS would have to pr...

I use http to remotely manage about 35 WAPs (1200 series) though out the US. The WAPs have different physical antenna configurations (ie, some WAPs have one antenna and some WAPs have two antennas, some have Omni antennas, and others have patch anten...

I have been evaluating WLAN solutions and have narrowed the choice down to two; AireSpace (Cisco) and Aruba. The one thing I really like about Aruba's system is that access points can be configured as IDS sensors only, which would eliminate some of t...

We are having problems with our 7920 phones as well as Spectralink phones roaming. We have no problems with our data terminals roaming. The phones and terminals are on separate Vlans on the same aps. The aps are running 12.03t. RSSI is above 20. Sepa...

Any chance Aironet 123x or older can be converted to use standard 802.3af power injector? Another question: Does the 1100 series have a field upgradable radio module similar to the 1200?

I have deployed a Cisco 1200 AP and was wondering what the best way to lower the broadcast strength is. I have lowered the CCK Transmitter Power, OFDM Transmitter Power and Limit Client Power settings to 1 on the Radio0-802.11G interface (which has h...

I am using an 851W configured with WPA-PSK and TKIP. I am getting an awful lot of messages in the log stating that a client has disassociated because it was leaving the BSSID, then the client immediately reconnects. I have duplicated this behavior wi...

Does anyone know if the Cisco Aironet 802.11a/b/g PCI Wireless LAN Client Adapter· AIR-PI21AG-E-K9will work on windows 2003 server, I'm not sure if it comes with the correct drivers, as very few Client adapters do.If not, can anyone recomend an adapt...

Been running WDS on a site with a number of APs for some time,mainly using wireless IP phones. I am using MAC authentication, and on the AP use the "dot11 aaa authentication mac-authen filter-cache timeout 36000" command to stop the APs going to the ...