Wireless

when deploying a wireless network for baggage reconciallation system in an airport,given the choice of cisco centralizd WLAN solution and cisco distributed WLAN solution, which one is better? If someone chooses the centralized one which uses LWAPP, w...

We have upgraded two ap1231 to 12.3.7-ja to make one of them work as a rootbridge, and one as a non-rootbridge.The problem we have is that the non-rootbridge will not authenticate to the rootbridge via the radio.Anyone that has made this work?

Hi We have some user PCs have both wired and wireless network connected at the same time.The 'route print' shows these Windows machines are using the ether0 as the default route to go out, which is correct.However when we use MS shared folder on thes...

Hi!I have two Cisco Aironet 1300, and i want to use the RSSI, my cuestion is..i need configure two bridges in Install-mode, or only one in instal-mode and the other in root mode?thanks

I cannot get my Aironet to pull a DHCP address using VLANS. If I debug on the Aironet, I do not even see DHCP request packets. I was under the impression that it would pull this automatically. I have 3 VLANS on the Aironet, a Dot1Q trunk to my switc...

Hi everybody,My question is about a passive rebound.I want to make BR1 communicate with BR3 with a passive rebound on the BR2 site:BR1-------BR2------BR3If i put a splitter on BR2 with 2 Yagi antenna, and if the ethernet port of BR2 isn't connected, ...

HiI know that in the documentation of the wlse the AP1200 is only mentioned in AP mode (http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cwparent/cw_1105/wlse/2_12/wlsesdt.htm#wp20790)but why doesnt it work in WGB mode? I have a site with abou...

Hello,I've got a Cisco Aironet 350 Bridge associating with another 350 Bridge (operating as a relay) to another (root) 350 Bridge.All bridges are running firmware revision 12.05The link between the Relay Bridge and the Root Bridge seems to be working...

I have a SSID setup with a 128-bit WEP key with a Cisco 1200 AP and a Symbol LA-4123 802.11b card (don't ask why). When I remove the 128-bit WEP key, I can connect to the network, but when I apply the key, no connection.With Symbol being such a big ...

I have a network with some Cisco 1200 Series AP´s. This ap´s have 802.11G radios. When I configure a new template, in the last pass (SAVE) I receivedthis message:Error processing template configurations. No valid device versions supported. This is th...

Hi there,I'm trying to synchronize my Cisco Access Points (AIR-AP1232AG-E-K9) Clock with our time server (win2k SP2).In the Web interface of the AP I can only enter an IP address an switch to "enable" but he is not synchronizing. I only get the follo...

Hi there,What we have now is 2 offices (A and B) 150 meters apart."A" has the server farm and the main WAN link. I just want to extend the lan of A to B (using 2 Aironet 1310 bridges which I already have), in a way so users in B can reach A (servers ...

HiI want to create a wireless bridge between two rooms in the same building. Can I do this with two Aironet 1131AG access points?Any useful information would be much appreciated.

Hello all,I have an aironet 350 series wireless card for my compaq iPAQ H3970. It is setup to use a server-assigned IP address but is having problems doing so.I have looked up troubleshooting documentation for this and a software reset of the device ...