Wireless

Hi,I am using an Aironet 350 PCMCIA client adapter with a 350 Access Point. When right-clicking a file located on a local LAN server share using the adapter in a Windows XP laptop, the hourglass comes on for about one or two minutes and then I get t...

I have found a doc on CCO that informed me that there was a problem between my ACS (v3.0) and my Active directory. What I do not understand is i have over 250 machines re-keying every 7 minutes and 99.9 percent work with out fail. Only a very small...

Hi ,Hope you can help me on this. Mobile IP is new to me. I have a core network using MPLS VPN, there are 4 major subnet in the network. All the gateways are on the PE router. I have wireless client who need to have roaming capability. a) Can I have ...

When selecting a station from the AP web interface one of the status messages is "Key Permute". I can't seem to find any documentation as to what this means. Any ideas? I suspect it might indicate TKIP??Thx.

What should the expectation be for running a point to point wireless set up with yagi antenna running full encryption packet loss wise???

I have 10 Aironet in service currently. I can reach 3 of them via SNMP request but 7 of them are unreachable. I've been to the setup page to activate it but it still the same. I use the last version of the firmware. Any idea ?Vincent

We have in our company more than 20 aironet 350. Each is connected sometimes to one host only. I would like to get the OID to get the IP address of that host or better to know the sysName of that host.

Hi All,I have a 5450 iPAQ with built in LEAP support. We use the 1100 Aironets on our WLAN. When I enable LEAP on the iPAQ the device never associates to the AP at all?I have debugged for "dot11 aaa dot1x all" on the AP but never see any events comin...

I just installed an ap350 and noticed the power injector LED flashing green instead of always lit.What does this mean ?When i disconnect the AP the led is steady orange...Please help,Lex van der LugtPQR - Holland

We have two buildings bridged with Aironet 350 and 340. The response has been very slow and there are quite a few CRC errors being produced (about 5-6 per sec) This bridges have been installed for sometime and were there when I took the job. I need...

I would appreciate the feedback for the following messages in wireless APRadio Enable Failed with error "Bad Authentication Type". Temporarily Disabling WEP Encryption and re-Attempting Enable. THIS ERROR MAY INDICATE TAMPERING WITH THE RADIO AND/OR ...

If I have a mixture of wireless Access Points, Cisco 350 and 3Com 8000, can I use a common external antenna from one or the other vendor? For example can I use Cisco antennas with 3Com Wireless Access Points?

should I be able to connect wirelessly to my Linksys BEFW11S4 Wireless Router with my Aironet 1200 setup as a repeater???I am having all kind of problems accomplishing thisThanksJR

Recently,my ap 350 showed following log information: Time Severity Description 00:10:22 (Warning): Failed to Send Packet on port "awc0" (error=0xffffffff) 00:10:22 (FATAL): Failed to stop driver for port "awc0" (error=0xffffffff)...

Hi,Does Cisco have any plan to come out with a inline power fiber media converter to support single mode fiber rather than a multimode fiber. The requirement is needed because I need to place an AP from the nearest wiring closet, but the distance is ...