Wireless

Hi folks,I experienced a few days ago, onde thing regarding AP 1100.I´ve tried to upgrade de IOS version, but in the middle of upgrade, the system crashed, and right now, I can not upgrade by Command line, or even GUI (GUI is unavailable). So, the le...

i have the IOS converted software from VxWorks and i currently have software version 12.2(11)JA3 loaded and i want to upgrade to the newest version or at least a later version so that i can enable WPA. when i try to use the HTTP upgrade page within I...

HI,I have got about 40 odd AP's in my network.I am using LEAP with Cisco ACS.In the client utlity i am not able to see Cisco AP name and its IP add.Initially i use to see this info on my client machine.I am using CB21 A/G cards.Can someone help..

I'm integrating a WLAN with Funk Steel Belted RADIUS, RSA SecurID ACE, Cisco 1230 AP and Odyssey Client.All the componete were installed following vendor instructions, verified several times.The Odyssey Client begin Auth, wait for Keys and reset the ...

I just ran the ADU 2.1 installation program to upgrade my ADU from v 1.3.0.9 to 2.1. After the upgrade I rebooted, and before the login prompt appeared, a "User Interface Failure" popped up, saying "The Logon User Interface DLL cscogina.dll failed to...

Hi allWe use WLSE for the configuration of the AP (1100g, 1130 and 1200). Since the IOS 12.3(4) version, we have to use a guest vlan (open, broadcast SSID and no mac address restriction) with our "old" radio networks (no broadcast, and mac address re...

Hello,Can anyone recommend a suitable tool?Fairly new to WiFi and require to perform a site survey to ascertain appropraite equipment deployment based on SNR, RF interference levels, etc.Tool can be shareware or commercial product?All help appreciate...

I have several 1220 802.11B AP's that I am upgrading from VX Works 12.01-T1 to IOS for adding G radios using the CAC Tool. During the upgrade process, an error occurs saying the AP doesn't have enough memory. Has anyone seen this message before, or d...

I have three VLAN/SSID interfaces configured on several 1210 APs (with in the same subnet). I have configured WDS with infrastrucure and client groups on one access point and set the others as infrastructure clients and it is working properly. Howeve...

I am having a problem with just about all of the access points on the network that are running VxWorks rebooting multiple times a day. This includes 340s, 350s, and 1200s. Not having the problem with any running IOS. The following messages show on al...

Guys,I have got access point AIR-AP1231G-A-K9. I can see two external connectors provided to connect the Antennas but I cant see any Antena attached? Do I have to buy them separately or something is builtin inside? Would it still work without Antenaa...

I have Cisco Aironet 1230 AP's and am having trouble getting the MAC address filtering to work. Configuration through the Web browser ALWAYS fails to work and says to do it through CLI. How do I setup this through the CLI? I've found some instruction...

What would cause overruns and underruns on Aironet Wireless Bridge (340). Is it a hardware issue? The other line of sight bridge is fine. Thanks.

None of my 350 PCMCIA client adapters connect to an air-ap1121G-a-k9 AP. I am using LEAP security onthe AP. If I use a a/b/g card I can connect fine. Anyone have any ideas what could be happening?

Looking at Nortel's wireless mesh. I wonder if anyone has tried to create an IRB bridge group using both the 11a and 11/b/g interfaces. The goal is to use the 11a interface for backbone connectivity...