Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
I configured an Aironet 1300 bridge point-to-point with root and non-root setup and did not select the beacon broadcast but i can still see the SSID being broadcast. Is there anyway to stop it? Any suggestion is appreaciated Thanks,
I configured an Aironet 1300 bridge point-to-point with root and non-root setup and did not select the beacon broadcast but i can still see the SSID being broadcast. Is there anyway to stop it? Any suggestion is appreaciated Thanks,
I have seen several post with the same problem after upgrading to IOS. The AP's can talk to each other but can not talk to the wired network. I have tried upgrading the firmware but still have the same problem. Has anyone found a solution yet?My firm...
Im upgradeing the aironets.I downloaded the firmware upgrade so that is is compatible with CAC from here http://www.cisco.com/cgi-bin/tablebuild.pl/aironet_350_series_ap .The file is a .img extension.When I go to the upgrade section and choose the fi...
Why the Bridge does not work with 100 mW in cck mode in Europe?
at what time you implement the bridge repeater mode in the RB1310?
I have 2 bridges, one with the built in 22 dbi antenna and one with the 9 dbi omni directional antenna setup at 700 meters with a clear site line for about 4 months.The signal strength wavers between -65 and -70, with no issues yet. Should the number...
We have a client that are using AP1200 with cisco PI21AG pci desktop cards. They are connecting to an sql server but intermitantly throughout the day they seem to get disconnected from the sql session. This only started happening since they went wire...
I try to setup this kind of installation but nothing The non root bridge can't associate to a wireless client or to another AP but only to the root bridge.In Cisco web site I read that this setup seem to be possible.How ???Regards,Salvatore
A customer has an LDAP directory as well as a Novell NDS directory. MAC clients authenticate to IPlanet LDAP. Windows users authenticate to Novell NDS. Is there any way to use multiple SSIDs and the unknown user policy to authenticate users against t...
The wireless clients use PCMCIA card to associate to 1200 series APs (latest ios 12.3(2)JA). The Authentication is LEAP and whenever it gets closer to another AP the LEAP authentication starts again which means the client disassociates & (loses its c...
I have an implementation that requires me to point 4 Yagi antennas (two pair of building to building Bridges) and was wondering what would be the best way to align them and if there is an automated tool to do so. I know that the 1310 has an LED in th...
We use a Cisco 350 PCMCIA for network communication on cranes. Some cranes lose the network contact to the access point while driving or staying in bad points of a hall, because of a too weak signal and/or signal overlays. This happens about one or t...
Bear with me, I need to set the scene.....We use catalyst 3550's where we have 3 VLANs. Port 1 is set in trunk mode and is used to connect to our WAN and is on Vlan 3. Vlans 4 and 5 are then used to seperate a secure and not-so secure lan.Now, we are...
Is it possible to configure 1200 AP to act as a DHCP relay? I need the AP to act as a DHCP client to a LAN based DHCP server but also forward DHCP requests received from the wireless interface so that clients may be assigned DHCP addresses. Anyone ab...
