Wireless

When is the WLSE 2.7 update going to be available for download. It was supposed to be available this past Monday but it's still not there.

We provide wireless to a university of 34,000 students, staff, and faculty. As you can imagine, our users have devices from a wide range of manufacturers, and we do our best to support them.Recently, I had problems with a few devices that couldn't co...

Hi everyone,I have a Router Wireless Linksys (WRT54G) and a Access Point Linksys (WAP54G) and I would like to know if there is the possibility to configure the AP as a client from router Wireless, I mean, the AP associates as were a client adapter.Th...

On the latest Firmware Ver.If client drops doesnt automatically reconnectGet error Interface Dot11Radio0, Deauthenticating Station (MAC) Reason: Previous authentication no longer valid I will get at least a couple of drops a day.Any ideas?

We are implementing an open/broadcasted ssid as service provider. According to cisco documentation, the wlse 2.5 we have bought is not so usefull for the radio planning and survey (requires, LEAP, WDS, OS min 12.13 JA1).Hence, I am looking to write s...

Hi All,I just confuse about EAP and LEAP, what feature can one do but the other can not? Is there any document in the web? Thank You!Best RegardsTeru Lei

cisco has promised a new product on proxy mobile ip,as the current one does not work. can somebody tell me the status and also how is the new product different from the current.

My consultation has relation with two subjects: 1-the corruption of drivers of nick Ethernet in notebooks evo n600 and n610 when inserting and to install the card wireless Cisco AIR-CB21AG-A-K9. 2-the second subject it has relation to slowness from o...

If I segment my wireless network into a different VLAN, I configure the port on the switch for that specific VLAN. What does it do when I tell the AP itself that it is in that VLAN?Will the AP act as a router to route traffic between the Wireless VLA...

It seems to be setup ok for 802.1x with WEP re-keying but we are not being assigned an IP address after connection is established. We have confirmed EAP-TLS works through our Radius box using a different AP, the Linksys WRT54G so it seems to be a con...

I have a static IP for the AP350 point running ios. When I turn off WEP (no EAP or MIC but 128 bit encryption manditory) I could get my IP address. When I reactivate the WEP (static key) I will not get an address. I have checked both the client and t...

pls give me a solution for a project to implement cisco wireless phone 7910g talking over wireless lan (WLAN) AP.

We have B AP's in production and we are currently moving towards G AP's and G Card. During this move we had G cards come in. We tested this connecting to the B aps. We get authenticated but could not get DHCP address. We use Leap Auth. Anyone know of...

Hi does anybody know if the Radius CA from versign works with Cisco ACS (http://www.verisign.com/products/wlan/index.html)i have asked cisco and versign, each of them told me to ask the other. Has anyobody implemented peap with versign ca?with ca fro...

Folks, I have installed about 10 access-points in a company. Everything seems to be working fine, except fast roaming. I had a question about overlapping channels. Since the access-points have G radios, i presume that you can have 8 overlapping chann...