Wireless

I have some older Cisco Workgroup Bridges but I have upgraded the firmware. I was curious if I could disable access for just specific mac addresses on the Ethernet port of a WGB340. I don't want to have to change anything in the authentication server...

I have recently upgraded an AP1200 to IOS - no conversion just a straight implementation of IOS code - absolutely no problems. Simple configuration with just an IP address, mask, and gateway. I used my laptop on the same subnet, etc. connected to a 1...

When I perform site surveys, I notice that no matter what data rate I select (1,2,5.5,11), there doesn't seem to be any difference in the signal to noise ratio. I'm asking this question because sometimes I want to create 2Mbps cells only, or 11Mbps o...

Since the above mentioned model came without any manuals I'm looking for the default user and passwords to configure the access point. I even did not know the ip but I was able to figure that out myselfThanks in advance

Why does the port that an aironet access point is connected to on a Catalyst 5505 with WS-X5012A blades go into Error Disable mode if you disconnnect and reconnect the aironet AP ?The AP is hard coded for 10Mb/s Half Duplex & the switchports are conf...

Hi, thereI have a question about RF tech.My company is notebook manufacturer.We produce many kind of notebook and include wireless lan card(802.1b).The default wireless lan card is using channel 6.So, We have thousand of notebook in channel 6 at manu...

We have a rather large wireless network in a hospital(voice and Data), seems to run o.k.We are using a vpn to authenticate to the wireless network, and running a program called meditech that the end user uses to chart patient info. Seem to be having ...

Hi,We have a customer with a data / voice need and were thinking about using the new 1400 series bridges.Anyone have any experience using these new bridges with voice and data?For our app, the remote site is only 500 ft. away with clear line of site....

Will TKIP work with AP350's, AP1100's and Dell true mobile cards. Or what is the best security solution for intermixing Cisco AP's with Dell True mobile cards in addition to WEP?Thanks.

Does anyone know if a yagi and my Aironet 350 or my Aironet 1100 will work together. How? thanks

I would like to know if everibody knows a standart form to configure the HOME AGENT and FOREIGN AGENT, becouse we have been trying to do it but it doesn work, if anyone knows a url or document please help us!!!Thank you.Oscar

I have 30 WAP 1200s. I need to get 100 7920 phone mac addresses in the MAC table for security. What is the easiest way to get all the MACs into the WAP config. I'm planning on manually entering the macs into one WAP and then copying and pasting the c...

Hi,I am planning a 802.11g wireless network with computers with softphone application. In this topology is it possible to overcome the design rule for G.729 calls is not to exceed eight concurrent VoIP calls per AP?ThanksRicardo

Greetings Members,The radio regulations in the UK for the 5GHz Band B (5.25 - 5.35 GHz) allow a maximum transmit power of 250 milliwatts. However, the current IOS software only allows a maximum of 40 milliwatts for both 'A' & 'B' Bands.Does anyone kn...