Wireless

HallooooI have already install cisco 350 bridge (use channel 2)and working properly a couple last days, but when I install senao (cordless telephone) working at 268 MHz for tranmitter and 394MHz for receiver then the problem start, like througput of ...

Hi, We, like a lot of folks, are doing our best to eradicate the latest worms. I'm presuming that infected wireless clients attached to access points are capable of infecting other clients in the same radio cell? If so, is there a way to protect them...

Hi,i try to define a mac-address filter for only 2 addresses (rest should be disallow)on an cisco 340 AccessPoint (sw: 12.03T).New MAC Address Filter: -> Dest MAC Address: -> Add -> ApplyNow the allowed address is on the "Existing MAC Address Filters...

I have a WLSE 2.0.2,When I try to import a template from an AP1200 IOS 12.2(11)JA1, it fails with a "Login failed. Wrong credentials" error.Monitoring the TCP connections at the access point, I see that the WLSE tries only a telnet connection that fa...

1. What is involved with an upgrade from 802.11b to 802.11g? Is this simply an IOS upgrade? The client would like 802.11g, but isn’t sure if they can simply upgrade, or if they should wait til 802.11g comes out.2. Would it be possible to segregate se...

At my school we are looking at relocating a computer lab (approximately 30 desktops) to a new room. Would it be wise (based on throughput) to make the new lab wireless or to have the room cabled? We are running both ipx and ip protocols on a novell n...

Can someone suggest the best way to set up wireless access for visitor’s (non company employees) internet access only. We would like to secure the access point so only permitted visitors could attach to the AP with the least administrative effort.I w...

I've been able to get MRTG to report on my AP340s, but when MRTG queries(SNMPv1) my AP350s they respond with an error status of noSuchName. For example this does not happen with the AP340s:====================Example error 1=====--base: Walking ifAdm...

I have been experiencing wireless association problems. These have developed over the past few weeks. The WLAN has been working well, up to now.I have used the 350 utility to few the noise and busy in this environment. I have seen 20-40% busy on vari...

Does anyone know when Cisco will have the 802.11a 54 meg bridges on the market? Has anyone tried another 802.11a bridge link?

I am having ACS, AP1200 and wireless Pc card.Some Pc card are configure without Leap enable.I would like to see the login activity message for those card that not Leap enable.Please advice that How to configure the AP or ACS in order to get the login...

Current SituationThe Bridges are Cisco 350 on both ends. The firmware is current. The Antennas are Cisco 21dBi Solid Dish’s. Line of sight is good. Straight line distance from one end to the other is 6.5 Miles. The Bridges are optimized for range. Mo...

Has anyone ever ran across this issue?Lost our association, associate response with status (17) from parentSetup350WGB Connecting to 340 Series Bridge set as APabout 80% signal across the board.ThanksJason Miller

I have about 20 350-series AP's with 350-series PCMCIA client adapters that have been in production for over a year now. Lately I've had several AP's in the field stop authenticating clients, although no configuration changes had been made. These AP'...

So I know you all must have been asked this a thousand times, but for those of us that missed the reply, why doesn't ciso offer a usb version of a wireless network adaptor to work with their equipment? I know of alot of people working with this stuff...