Wireless

I am looking at connecting a number of dipersed sites each equipped with a 350 series bridge and a yagi antenna to the central office LAN equipped with a 350 series bridge with an omni directional antenna. What is the maximum number of sites that I w...

I want to connect one or more National Instruments devices (FiledPoint 2010) with ethernet interface to my LAN by a wireless connection.FielPoint 2010 devices ara located in the space in front of my site building within an area of less than 100 meter...

I have been asked to look into providing access to our wireless network using a VPN solution. I have tried looking in the previous posts regarding this issue but have yet to find a definitive answer. Currently we have a huge wireless infrastructure u...

I test AP1100 and AP1200 by connect port ethernet with swith both unit.When i pull out power adapter of AP1100 why port ethernet of AP 1100 at switch have blink at LED 100 and FD/COL . ANYbody can help me this ploblem.

hello all,snmp agent is runnig on cisco 2900 switch and i am unable to connect to it at 161 port. Why is it so and how can i connect please help

I have been reading through the conversations and have not found anything addressing this. (one post was close but there was no response since March 6th to the customer).We have 4 BR350's in a WISP mode. We have the following settings:1 Mbps = YES2 M...

originally i had wlse 1.3.1 and 1220s, 340s, and 350s. i got the wlse to discover all of the ap's and i was a happy man.now i have upgraded my 1220s to IOS. the 340s and 350s haven't changed. and i upgraded the wlse to 2.0. now i can't discover anyth...

Hello all Cisco users!I am experiencing an extremely slow web-browser interface. I click on any menu option such as EXPRESS-SETUP, NETWORK MAP, ASSOCIATION, etc. and the IOS takes more than 30 secs to send the page to my browser.In a normal situation...

I have a few Aironet AP1000-E's and I am looking for more info on these units; I found the User's Guide for the 2000 and 1000 series WAPs for Ethernet on Cisco.com (after much searching)...Of course, this is a small (12 page) manual and it refers me ...

These are the IOS version and Firmware version for my client : AP1100 : c1100-k9w7-mx.122-8.JA Aironet 350 Client Adapter : V5.02.19 These are my setup, and both running on non-overlapping channel within 10 feet. Switch / \ AP AP Things configure at ...

Design condition1) point to point only 2) no any voice gateway or callmanager3) low costIs the following design possible ? (analog phone & ethernet device) - ata188 - wireless bridge 350 -(wireless)- wireless bridge 350 - ata188 - (analog phone & eth...

After successfully uploading the flash via ftp, the image was decompressed and in the middle of the process it went south. I reviewed other posts and found the unit had been sent to the factory or the owner was out of luck. Is there a do-it-your-self...

On a Aironet 350 non-root bridge is it possible to disable 801.1q bridging on the Ethernet port only? ie leave it on the Radio side side only

I have tried to upgrade the firmware on a 340 bridge, the FTP transfer was ok bu then the unit crashed when it tried to uncompress the image. The unit is now unresponsive, it has a solid red LED and I cannot access the console port. Is this unit now ...