Wireless

I asked if the firmware upgrade makes the older 350 Series Wireless Bridge to support 802.1q. The answer was that it is possible to upgrade both 350 and 340 Series Wireless Bridges to support 802.1q.Which version of firmware is needed for VLAN suppor...

Can I get some help setting up QoS on a bridged network? I'd like to set it up so that SNA sessions are given priority over everything else.ThanksMike

how do i secure a leased wireless tunnel between a cisco 2500 at the remote site and a cisco 7200 at hq. The leased wireless tunnel is provided by an external company that uses clearwire equipment.

win2k IAS-RADIUS is setup with PEAP + a server cert with 802.1x updateaironet 1100 setup with dyn wep + rootclients setup with WEP _Authentication - PEAP - eap-mschap v2 + validate server certOn a reboot, the card will not connectIAS says computer ha...

Aironet 1100. Running win2k Radius+ PEAP + certificate + wep.We can authenticate fine if the user is already authenticated into the computer system. He can log off and log back in, provided he doesn't reboot and connects just fine.But from a reboot/b...

I'm new in this technology and don't have any experience in this technology. Can I create VLAN in WLAN equipment if no, what is the options that I have to seperate the LAN? How do I protect a secure site using a WLAN? Hope anyone can help.Thanks

I`ve set up three Bridges in a line, the two on the outside each have a yagi pointing to the middle bridge. The middle bridge has a 2 x yagi`s pointing out in each direction on the two ports. I am getting a bandwidth drop to 1Mb when transporting lot...

Hi. I have a 350 with IOS 12.02T1 and XP is running FW v5.20.17 and NDIS driver v8.3.10. I am not using any network auth just 128bit WEP. When I set up a simple network it works, but if I enable MIC and TKIP I cannot get an IP address! I seem to auth...

Hi !!Many PDAs etc. today cannot accept PCMCIA cards but they do have a slot for a compact flash card (many with support for network cards...).Other vendors supply wireless LAN cards in CF form factor...Are there any plans for such a card from cisco ...

Hello, I'm trying to get using snmp who is the root bridge, from a non-root bridge- Although I've found an OID awcDot11TpFdbCurrentBSS - 1.3.6.1.4.1.522.3.12.5.1.15which is supossed to give me the BSS to which the station is currently associated, I g...

Hello!The new Cisco Wireless Bridges 350 Series have 802.1q support. Is it possible to upgrade the old 350 Series Bridges with the last firmware to get this feature on the old 350 Series equipment.Thank you very much,Valery

HiI have the problem with an AP340 (i know this is old ). We use leap and i have the newest sw 12.03t. everythink works fine, but i alsways see the eventlog messages on the HOME screen:2003/06/25 14:57:28 (Warning): RADIUS verification failed for Ser...

Have two 350 series bridges connecting 2 LAN that are about 100 meters apart. The installer used omni antennas. I can connect across the bridge fine when the bridge is NOT connected to the production LAN at the central site. (I have a PC and the brid...