Wireless

Is it possible to make the AP1200 as a bridge unit? what I can see from the role selection is repeater/non-root option.regards, Sam

I have a Linksys Wireless Router running on 2.4ghz using a DSL Connection. I want to setup an old Cisco Aironet 350 Access Point as either a WIRED Bridge or a Wireless Bridge to boost the signal to my backyard office.I have the Ciscp AP Ver 11.07 con...

I am using Cisco AP352's as AP's on a WISP network. I have customer's buying their own CPE and most talk just find with the 352's. I have one customer that has bought a Smartbridges AirPoint Total. It does not seem to want to associate with the Cisco...

Hi,Can an AP support Cat 6 cabling in future?What is the MTBF for a 1200 Series AP?Thanks.Regards,Delon

Under NETWORK INTERFACES on a AIRONET 1200 I get 'Radio0-not installed' and 'Radio1-not installed'. This is brand new access-point running 12.2(11)JA . I have reset it to factory defaults and reloaded all the firmware. Any help?

Hi,I am relatively new to wireless networking and have a customer site to set up, but I am not sure what equipment I need to make it work properly. Here is the situation:Building A has roadrunner business connection.Building B needs access point to c...

I've noticed for some years now, that periodically, a cisco wireless pcmcia card will lose its association to a cisco ap with which it has strong signal. The association instantaneously comes right up, and this has never been of serious consequence, ...

I have a question about setting up VLANS on the AP's. I've configured a user VLAN on an AP w/ 12.02t1 code. I've also tied a new SSID to the VLAN. I'm trying to migrate users from our old configuration where broadcast SSID was available to a new conf...

Does anyone know how you can test to see if your bridge is processing or even detecting QOS packets? Is there an event log or setting which will show this?

Hi all,I have got the authorization done and the link working. but i cant ping from lmy latop to the AP or to any other deviceo n the backbone.pls help.thx

Hi AllI have got a PCMCIA and AP both 350 series. configured the PCMCIA with ip 192.168.1.125/24 - with profile of the ssid and a open authentication. on the accesspoint i have an ip 192.168.1.11/24 and with the auth to be OPEN. now my card autentica...

I am designing a wireless ethernet radio network for a rail system using Cisco Arlan AP350 Access Points and WGB350 Work Group Bridge radios . Comunications will be between a land based LAN and mobile trains in the rail system. I would appreciate hel...

I am unable to get separate 350 bridges to do etherchannel since upgrading CatOS on 5509. Upgraded software on 5509 from 4.2 to 5.5.5509 connected to 3512 running 12.0 IOS.3512 config Fa0/3 port group 1 distribution destination Fa0/7 port group 1 dis...

I'm using a Cisco Aironet 340 pcmcia radio on a Apple PowerBook G4.I notice that the Aironet Status Utility allocates about 4KBytes of memory a second. (checking memory utilization via top).If I leave the machine powered on for several days, the memo...

Hi,Today our AP-1200 running 12.01T1 stopped passing DHCP requests (to DHCP Server) from Wireless Clients. I did some testing 1. Our DHCP server was working , as i can get an address when connected physicaly to the network.2. Wireless association to ...