Wireless

Hi all,I have a 1200 Series AP , What is the maximum MTU size of 1200 Series ?and Can I fix the size ?Thanks in advance.......

Could someone help me figure out how much loses does the 150ft ultra low loss cable compared to the 100ft ultra low loss cable?Thanks!

Configuring a 1230 AP as a "Local Radius Authenticator"CCO-URL: Configuring an Access Point as a Local Authenticatorhttp://www.cisco.com/en/US/partner/products/hw/wireless/ps4570/products_configuration_guide_chapter09186a0080184a9b.htmlthis is the mi...

I have been trying to install a 350 PCMCIA card on a laptop running XP SP 1. However, I cannot get it to work reliably.I set up the XP networking profile for PEAP and GTC I set up the ACU for Host based EAP and Dynamic WEP.The process is slow to brin...

Hi,I am using WLSE 1.3 and using AP350 12.01T. It always give me snmp unreachable. unable to read cdp cache. What can be the problem. I put the seed device as the switch that is connected to the AP and the device credential is the AP that I am going ...

I read some wireless document. Some terms are very confused.1. WEP session key2. WEP broadcast key rotation.3. Transmission key.

HiJust curious if there is a way to monitor the traffic flowing through an Aironet 1200 series device to allow for billing per IP/MAC address??I can seem to find anything on this...

Is it possible to connect a PCI352 client to BR350 acting as an AP 10kilometers away?Thanks!

I asked if the firmware upgrade makes the older 350 Series Wireless Bridge to support 802.1q. The answer was that it is possible to upgrade both 350 and 340 Series Wireless Bridges to support 802.1q.Which version of firmware is needed for VLAN suppor...

Can I get some help setting up QoS on a bridged network? I'd like to set it up so that SNA sessions are given priority over everything else.ThanksMike

how do i secure a leased wireless tunnel between a cisco 2500 at the remote site and a cisco 7200 at hq. The leased wireless tunnel is provided by an external company that uses clearwire equipment.

win2k IAS-RADIUS is setup with PEAP + a server cert with 802.1x updateaironet 1100 setup with dyn wep + rootclients setup with WEP _Authentication - PEAP - eap-mschap v2 + validate server certOn a reboot, the card will not connectIAS says computer ha...

Aironet 1100. Running win2k Radius+ PEAP + certificate + wep.We can authenticate fine if the user is already authenticated into the computer system. He can log off and log back in, provided he doesn't reboot and connects just fine.But from a reboot/b...

I'm new in this technology and don't have any experience in this technology. Can I create VLAN in WLAN equipment if no, what is the options that I have to seperate the LAN? How do I protect a secure site using a WLAN? Hope anyone can help.Thanks